answersLogoWhite

0


Best Answer

The firing order for a Chevy 350 V-8 5.7 is 1-8-4-3-6-5-7-2 and is mark on the intake housing in the top of your engine

what is the position of the rotor for the #1 cylinder?

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the firing order for a Chevy 350 5.7L?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What do it take to put a 350 57L in a 2000 S-10 22L pickup?

Lots of time, patience, and money.


How many wire hookup is an alternator on a 95 57L 350?

not enough information what type of vehicle does it have a idiot light or gauge


How do you change the power steering pump on a 96 Chevy suburban with a 57l vortec?

need a puller to remove the power steering pump pulley, then remove the bolts holding the pump on


Can you put a 1991 350 57L in a 2000 S-10 truck?

Any thing is possible just depends on how much you want to spend and also where you live if you have state inspections then no if not then try S10v8.com or jagsthatrun.com


1995 Chevy k15000 57L TBI no spark changeds ignition module coil cap rotor wires and plugs could it be a fautly module out of the box?

more apt to be the engine control module


Where are the timing marks located on a Chevy van g20 57l?

If this is a 305/350/400 small block Take the lead from the coil to the distributor "OFF" to prevent the engine from firing. This will take two people or a remote starter. Turn the engine over until the mark on the tortional damper lines up with the center or O mark on the timing tab on the front of the engine fastened to the crankcase front cover and the engine is in the number one firing position. This may be determined by placing fingers on the nuber one valve as the mark on the damper comes near the O mark on the crankshaft front cover.If the valves are not moving the engine is in the number one firing position.If the valves move as the mark comes up to the timing tab the engine is in number 6 position and should be rotated one more complete turn to bring it to the number one firing position. Also take the cover off of the distributor to determine that the rotor is positioned properly pointing to the number one spark plug then follow the firing order for that engine should be 1,8,4,3,6,5,7,2 Wayne


Is 1 ton of topsoil more than 57L?

Topsoil varies in weight, depending on the type and texture, so it really depends.


Where exactly is the oil pressure sensor on a 1990 Chevy 350 57L and what is plugged into it?

the oil pressue sensor should be in the rear of the motor just behind the manifold there are several types but a 1 wire or hose should hook up to it I was afraid of that -- that's what the Chilton's manual says, too, but it doesn't tell me whether I have to remove the distributor (and I can't see anything that looks litke the new sensor I have). Do you know? Ding, ding, ding, we HAVE a winner!! I found it -- for anyone else in search of the elusive little thing, it's UNDER the distributor cap.


My Prada sunglass lens is scratched willI Prada Luxotica have them refurbished if I send them to have this done?

prada spr 57l 1bc.1a1 120 3n


Are the spark plugs different on 95 chev caprice 43L V8 and 57L V8?

as far as i know the 4.3 is a v6 which is actually based off of the 5.7. gm just cut 2 cylindars off if there is a difference it will be the heat range on the plugs for your info, the Chevy 4.3 ltr in a 94-96 caprice is a 265 v-8, do some research before giving info on engines you know nothing about. oh and by the way, the power rating in a stock 4.3 v8 is higher than a stock 5.0 and also the correct answer is NO, the spark plugs are no different than the 305 or the 350.


Is there a coil wire that goes to the optispark on a 95 Pontiac firebird with a 57L LT1 and where does it go?

The wire goes to the coil, which is bolted to the drivers side head in the front of the motor.


Where is the PVC valve located on a 2001 dodge ram 1500 57l?

should be in the top of the valve cover on the passenger side and i believe you mean pcv valve right?