1/2 OD or ID as copper is measured by OD BUT in Plumbing rather then saying 5/8 L tubing we say 1/2 BUT 1/2 in ACR work is actually plumbers 3/8
The flow rate is about 7.5 to 10gpm Plenty for up to 3 low flow shower heads.
Flow rate of what fluid (water? air? oil?)
Also, what is the length of tubing and at what temperature or viscosity?
This question is literally impossible to answer correctly because there is no given size or pressure of the liquid or gas travelling through it.
To provide an answer to this question the pressure of the fluid applied at the input end of the pipe must be provided.
4324
By knowing the availabe pressure and the diameter / material of the piping
300mm is a very low head, you can't expect much flow through that pipe, but you can work it out from the mechanical energy balance equation.
if u r talking about presuure drop then it can be easily calculate with the help of relation 4flv*v/2gd in that f is the friction factor which is different for vraious type of flow for that u have to search a good book of fluid mechanics, v is the velocity. length of pipe and d is diameter of pipe
80 gpm
To provide an answer to this question the pressure of the fluid applied at the input end of the pipe must be provided.
At constant pressure and constant fluid density, larger pipe results in larger flow rate.
Water flow rate half inch PVC pipe 65 psi?
Measurement of flow rate in a pipe
It reduces the flow rate.
The flow-line of a pipe is the bottom inside portion of the pipe. Flow-lines are generally reffered to when establishing the elevation of the pipe work.
You would still need the coefficient of friction for the type of pipe in order to calculate flow.
Yes, easily.
10gpm
The velocity of flow in any pipe is determined by three things. The internal pipe diameter, the mass flow rate of the liquid and the fluid density.
What is the maximum flow rate of a two inches in diameter of a pipe in cubic meter per hour?ImprovecapitalOneround('alternateMsg');