answersLogoWhite

0


Best Answer

coax is 200 meter maximum ,if you want more than 200 meter(video transmission) you can even use cat 5 cable with video transmitter and receiver adapters and it will be the cheap and best way.

futronicservices@gmail.com

User Avatar

Wiki User

13y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

13y ago

Thinnet coax is 10base2, which gives a maximum speed of 10 Mbps

This answer is:
User Avatar

User Avatar

Wiki User

13y ago

10Base2 thinnet coaxial cable is 200 feet. but its rounded up to 185. the 2 stands for 200. so the answer is 185.

This answer is:
User Avatar

User Avatar

Wiki User

15y ago

185 m

This answer is:
User Avatar

User Avatar

Wiki User

15y ago

500 meters

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the maximum distance a Thinnet coax network cable can run?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the most common type connector used with coaxial cable on a ThinNet Ethernet network?

BNC


What is the most common type connector used with coaxial cable on at ThinNet Ethernet network?

BNC connecter


What is the most common type connector used with coaxial cable on a ThinNet internet network?

BNC Connector


What network access uses radio frequency or other means of media free transmission?

Thinnet 10BASE2 cable


Maximum cable for 10 baseT network?

325 feet


What is the maximum signal distance on a cat 5 cable?

The maximum length of a cat 5 e cable with out a repeater is 100meters


What type of terminator is required at both ends of a Thinnet or Thicknet cable?

50-ohm


What device can you use for having maximum bandwith in a PC connected in a network?

Router having maximum bandwidth in network. and in network fiberoptic cable having max bandwidth for data travaling


What is the maximum lenght of a cable on a 100BaseT network?

100 meters or 328 feet


What is the maximum distance of a 100Base TX cable?

100 meters.


The maximum segment lenght on a 10BaseT network is meters?

10BaseT is another name for co-axial cable. It has a maximum cable length of 185 meters or 607 ft.


What are physical communication media?

# Twisted pair - Wire twisted to avoid crosstalk interference. It may be shielded or unshielded. #* UTP-Unshielded Twisted Pair. Normally UTP contains 8 wires or 4 pair. 100 meter maximum length. 4-100 Mbps speed. #* STP-Shielded twisted pair. 100 meter maximum length. 16-155 Mbps speed. Lower electrical interference than UTP. # Coaxial - Two conductors separated by insulation such as TV 75 ohm cable. Maximum length of 185 to 500 meters. ## Thinnet - Thinnet uses a British Naval Connector (BNC) on each end. Thinnet is part of the RG-58 family of cable*. Maximum cable length is 185 meters. Transmission speed is 10Mbps. Thinnet cable should have 50 ohms impedance and its terminator has 50 ohms impedance. A T or barrel connector will have no impedance. Maximum thinnet nodes are 30 on a segment. One end of each cable is grounded. ## Thicknet - Half inch rigid cable. Maximum cable length is 500 meters. Transmission speed is 10Mbps. Expensive and is not commonly used. (RG-11 or RG-8). A vampire tap or piercing tap is used with a transceiver attached to connect computers to the cable. 100 connections may be made. The computer has an attachment unit interface (AUI) on its network card which is a 15 pin DB-15 connector. The computer is connected to the transceiver at the cable from its AUI on its network card using a drop cable. Maximum thicknet nodes are 100 on a segment. One end of each cable is grounded. 3. Fiber-optic - Data is transmitted using light rather than electrons. Usually there are two fibers, one for each direction. Cable length of 2 Kilometers. Speed from 100Mbps to 2Gbps. This is the most expensive and most difficult to install, but is not subject to interference. Two types of cables are: 1. Single mode cables for use with lasers has greater bandwidth and costs more. Injection laser diodes (ILD) work with single mode cable. 2. Multimode cables for use with Light Emitting Diode (LED) drivers. All signals appear to arrive at the same time. P intrinsic N diodes or photodiodes are used to convert light to electric signals when using multimode.{| ! Media ! Distance(meters) ! Speed ! Approx Cost/station | UTP 100 4-100Mbps $90 STP 100 16-155Mbps $125 Thinnet 185 10Mbps $25 Thicknet 500 10Mbps $50 Fiber 2000 100Mbps-2Gbps $250 (multimode) |}