0
What is the plug wire placement on the HEI ignition cap and standard firing on a 1989 Chevy 350ci?
Wiki User
∙ 18y ago
firing order 18436572 placement on the cap 1 is located two poles counterclockwise from connector port. connector port should be at three o clock position facing the drivers front fender New to Chev v8s whats a connector port?? I think it was to be "post". There are 8 brass or aluminum posts on the top of the distributor that are "fired" by the rotor. The firing order is 1-8-4-3-6-5-7-2. My HEI distributor has number 1 as the first post colockwise past the external plugs and at about 5 o'clock when the timing is set to 10-12 degrees BTDC. Remove your number one plug attach a cylinder compression gage and rotate your ing
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
What is the firing order 1973 Corvette with points ignition?
The firing order for a 1973 corvette 350ci and the optional 454 is 18436572 Firing order remains the same for breaker point ignition as well as HEI electronic Position of #1 plug wire on distributor cap changes slightly when converting to HEI from a standard breaker point ignition system...............sfvrider242
What is the 1996 Chevy k1500 350ci ignition timing?
It should be located on a tag under the hood.
1991 Chevy G20 van firing order for the block and cap please?
If it's a 350ci the firing order is 1-8-4-3-6-5-7-2
What is the firing order for a 1993 GMC Top Kick?
If it is a 350ci engine the order is 1-8-4-3-6-5-7-2
What is the plug wire placement on the ignition cap and standard firing on a 1977 Chevy 350Ci?
1,8,4,3,6,5,7,2 is the standard firing sequence on ALL small and bigblock Chevy V8's.Do you have points or electronic?If electronic,see the part on the cap of HEI ignitions that sticks out from the left?Clockwise,# 1 cylinder terminal is the second one(approximately the 5'oclock position,same with points ignitions)Start with cylinder # 1.This is the cylinder on the drivers side.Very first one.Connect plug wire from Terminal # 1 to cylinder # 1.Next in line is cylinder # 8(approximately the 7 o'clock position).Connect plug wire from terminal # 8 to cylinder # 8. On the left side of engine are cylinders 1,3,5,7.On the right side of engine are cylinders 2,4,6,8.Continue the sequence above clockwise.If you have points,MSD,Crane,etc.,dont forget to connect your coil to the terminal in the top of the cap.
What is the TBC suffix codeon small block Chevy?
With only that info it could be, 1970, 350ci, 255 HP, 4 bbls, K10 & K20, C10 to 3500, standard 3 spd or a/t, or 1979, 350ci, 165 HP, 4 bbls, C10 to 2500, conv. cab, manual trans, fed.
How much horsepower does a 1978 corvette have?
With the base L48 350ci V8 it puts out 185HP and with the optional L82 350ci V8 it puts out 220HP.
Motor for 97 z28?
lti 350ci
What year did Chevrolet bring out the 350ci?
1968
What kind of engine is in a 1977 Corvette?
The base engine is the 350ci L48 V8 that puts out 180hp and the optional engine is the 350ci L82 V8 that puts out 210hp.
What are the signs if an ignition module going out on a 92 Chevy silverado with a 350ci engine it will crank but not fire but when it fires it runs fine?
after truck warms up will be hard to start,module may even start turning white colored make sure you are getting 12 volts to the module from the ignition also good luck
What is the horsepower of a stock 350ci in a 84 camaro?
appx. 195hp
