4 and one half inches
Side of van along the frame Behind front wheels and in front of rear wheels Side of van along the frame Behind front wheels and in front of rear wheels Side of van along the frame Behind front wheels and in front of rear wheels
In front wheel drive the traction comes from the front wheels while in rear wheel drive traction power comes from the rear wheels.
The front is (probably) a direct fit. The rear probably not. Track rear Wheels are likely to use a narrower axle spacing than a multi-speed rear. If it's a steel frame, it can be respaced - Cold set - to a narrower spacing, and the dropouts realigned. There's a limit on how many times you can do this, so Think carefully if you'd ever want to turn it back into multi-speed again.
for better traction!!
Rear or front wheel drive id not determined by the wheels themselves. It depends on which wheels are connected to the driveshaft. If the driveshaft, from the engine, transfers power to the rear wheels to accelerate the car then it is rear wheel drive. Likewise to the front, though it is then front wheel drive.
From the sides behind front wheels there is a member pad. In front of the rear wheels there is a pad for jack. Do not lift from side of body or center of rear wheels. It is OK to lift from front center of cross member.
The 1998 CR80 (GBF) wheels are 16" rear and 17" front, and were not designed for a CRF150R, but it has a 16" rear and 19" front. The rear wheel is likely compatible, just not the front wheel.
All wheels stay on the side that there on now. move front wheels to the rear and rear to the front. Do not change sides.
Chevy done that on 4-wheel drives so when your off road with it the rear wheels are always grabbing a couple inches of un touched ground where the front wheels did not touck. That is called tracking. It's so the rear wheels don't run in the same place that the front wheels run. Better traction.
If the front wheels are on a tow dolly, the rear shaft will need disconnected.If the front wheels are on a tow dolly, the rear shaft will need disconnected.
They have 3 wheels, 2 rear and 1 front.
Install the chains on the drive wheels.