For some network issues, you'll need to update the settings for your router. Every router has different ways to configure it. However, most manufacturers provide a router configuration web page to edit router settings. You can usually open a router's configuration page by going to that router's IP address on the network. == # On your computer, click Start, Run, type cmd, and press ENTER. A window with a command prompt will appear. # In the window, type ipconfig /all and press ENTER. # Look for a line that starts with "Default Gateway" and write down the address (usually it will be 192.168.1.1 or 192.168.2.1). == Open a web browser, and in the address bar, type http:// followed by the address you wrote down. Press ENTER. The layout of the router configuration page varies by model and manufacturer, but you should be able to browse the pages to find the settings you're looking for. Some settings on your router may be easier to find than others. If you need help finding a particular setting, consult your router documentation or go to the manufacturer's web site for instructions.
To connect to a terminal for initial configuration
You need to buy a wireless router than has ethernet port if you want to connect a PC and a laptop to a Motorola surfboard sbv5220 cable modem.
That's where the router's startup-config (startup configuration) is stored.That's where the router's startup-config (startup configuration) is stored.That's where the router's startup-config (startup configuration) is stored.That's where the router's startup-config (startup configuration) is stored.
it wont work because it need an ip address. an ip address doesn't go through a Motorola modem. but i will go through a router.
yes i can
Any problem like this should be approached by testing step by step, so:Can other laptops connect to the router? If not then, it may be the router or the connection to the ISP.Can you connect with a network cable? If that works, then there is a problem with the WiFi - the configuration may be wrong, the connection may be too weak, it may be turned off in the laptop or the router. It may actually be broken in the laptop or router.
You don't have wireless network cards you have to buy it or you have to get a lan cable(s). After that connect your router to the modem if you have it. And connect all your computers to the router. Usually default settings allow you to work with internet and inside network without any correction of default settings. After that restart your modem (if you have it) and restart your router. Then Start->Run->cmd, press enter. ping (one of your computer's Ips), for instance, ping 192.168.1.3 If it doesn't work out you have to configure DHCP server for your router, but it's already another question.
I'll go to hellis Cisco in a Cisco router. What would the prompt look like for global configuration
You do not have to connect your router to your PC via ethernet cable, you can instead connect via wi-fi and your router must be connected to your hub.
Check to see if your router has a 'reset' button. This button usually resets the router to the default factory configuration. Of course, it is best to have the user's manual when doing this so you know how to reconfigure the router.
State four typical router configuration file items?
The reset button in a router let you remove all the configuration you do and gives you the default configuration from factory.