A little late to the party; however, I think I’m just in the nick of time to save someone time and $$. The CORRECT answer, per the manual is: 33lbs/ft for all trim levels (ex. DX, LX), with the exception of the EX that only gets 29lbs/ft.
20 lb/ft would be sufficent until you find the exact figure.
it is next to where to mount the oil filter. it is either 17mm or 19mm with 58 lb torque
2006 honda odyssey engine oil drain plug torque
27 foot pounds
94 civic transmission fluid drain
33 foot pounds
The engine coolant on a 1991 Honda Civic is replaced by turning the drain petcock and releasing the coolant. The filler cap is then removed and coolant added until the system is full again.
The correct tightening torque for a 1990 Honda Accord oil drain plug is 29 foot pounds. This same torque applies to all Honda oil drain plugs.
17 mm.
The 2004 Honda Civic has a conventional wet sump lubrication system design. Therefore as in most modern vehicles the oil drain plug is located under the car at the bottom of the engine oil pan.
You will have to syphen.
civic dx auto trans should not be flushed.Just drain pan and clean magnetic plug and add 3.2 litres of genuine Honda atf.Drain again in about 6 month so you capture the fluid in torque conv.
The coolant drain plug on the 1993 Honda Civic is located right below the manifold bolts close to the transmission side. There is another drain plug located on the back of the block left of the fuel filter.