answersLogoWhite

0


Best Answer

There is no typical setback distance. It can depend on local law, state law, the lay of the land or the developer's preference. You might try calling a registered surveyor in your area and ask what setbacks are most frequently used in your particular area.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the typical distance between the property line and building setback line?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How close to property line can you build a pool?

According to eCode360, the building setback is 25 feet in the front. The regulation also explains that the setback for the side of the property is 10 feet.


How far from property line can you build a sun room?

It depends on the setback requirements in the property's zoning. If it's zoned, the zoning regulations will state how close any part of the building can be to the property.


What is the law in Illinois for property line setback regarding fence installation?

Fences are governed locally. You need to call your town building department to determine the rule in your locality.


How far does a have to be from a property line?

Rules regarding the installation of fences and setback lines are governed locally. You need to call your local building department if you want to know the rules in your community.


If I did not ask the neighbor to move his fence back from the property line when I bought the property can I make him move it 10 years later?

You are asking if you have the right to ask your neighbor to move his fence back from the common property line. Fence lines and set backs are governed by local ordinances. In my area a homeowner can build a fence directly on the property line. There is no setback rule.You need to start at your town building department and ask if there is any setback rule in effect in your town. You should find your answer there.


What is the minimum driveway setback from property line in Phillipston ma?

15 feet


How does a building section help in analyzing a street?

If you are drawing a building section, it's always more thorough to include it's proximity to the street. The first reason for this, is a building is required to meet a setback distance from the street per code. The building department will be looking at your drawings to make sure you are within those setback regulations. The second reason, is that it is always nice to see the relationship of the building to its surroundings. The whole point in drawing up a set of plans is to tell a story. An analysis of the street is usually done by a civil engineer.


What is the setback to build a house from property line in ft worth tx?

Front yard: 20 feet maximum setback, with the following provisions: a. Campus developments: Interior buildings constructed as part of a campus development may be set back from the property line more than 20 feet if at least 50 percent of the public street frontage on each block face within the development contains buildings within the maximum setback of 20 feet. Interior buildings set back farther than 20 feet may not be constructed unless and until this 50 percent requirement has been satisfied. b. Buildings may exceed the maximum 20-foot setback if angled, perpendicular, or parallel parking on private property meets the conditions of Section 4.1002.D.4.e. In these situations, the front yard setback shall be measured from the front of the parking space instead of the property line, and the setback shall be no greater than 20 feet. c. Buildings on corner lots are required to meet the front yard maximum setback on primary and side streets. d. To allow convenient access to parking from the front entrances of large retail buildings greater than 50,000 square feet, the building side of any internal street with a public access easement may serve as the line from which the setback is measured. The total ground floor area of buildings utilizing this exception, however, shall constitute no more than 50 percent of the total ground floor area of buildings shown on the conceptual site plan. 4. Rear yard: 5 feet minimum setback. 5. Side yard: Setbacks are required when an abutting property with an existing building has windows facing to the side. Then, any new development or addition shall provide at least 10 feet of separation between the existing and new building. Note: Additional setback conditions are included in Section 4.1002.G. Other Development Standards.


How far from property line can build?

It varies. "Setback" - the distance between improvements and the property line - is usually prescribed in a given locality by zoning, which is a unified plan indicating which uses are allowed in specific areas. So the answer can usually be found by contacting the zoning authority for the city/county/municipality where the property is located.


What is the difference between setback and drawback?

A setback can be referred to as a bump in the road or some obstacles that causes you to regress. A drawback is a con or a disadvantage.


How do you measure your wheelbase?

The distance between the centers of the front and rear wheels. Measuring and comparing the wheelbase on both sides of a vehicle can identify rear axle misalignment or front wheel setback.


What is the minimum setback of home from property line in brick NJ?

You need to call your town or county offices and inquire there.