answersLogoWhite

0


Best Answer

A dormer is a small piece of roof that projects from or is not in plane with the main roof plane. It has a junction with the main roof and this junction is where the flashing is required.

Dormers can vary in shape, so the exact form of flashing required will vary. The type of flashing also depends on the roofing material, and whether the same material is on the main roof and the dormer roof.

If the main roof plane and the dormer are of the same material, the flashing can usually be the same as used on a similar junction of the main roof.

Important parts of a basic flashing are:

* it laps from under the upper or higher roof cladding so that water will run down onto it from the higher cladding, and it laps over the lower roof cladding so that water running down it will run onto the lower cladding, rather than underneath the lower cladding. Flashings that run parallel to the fall of the roof are a little different but follow the same principle: look at the path the water will follow. * It is lapped a sufficient distance under and over the cladding to prevent water seeping back. This distance will depend on the roofing material, the material's profile, the strength of wind in the area and the rainfall of the area. * It may also need a return or kickback on the flashing to prevent capillary action or wind driven moisture. Flashing materials must be compatible with the roofing material. Water running over some materials will collect ions that may make materials that this water then runs onto be stained or corrode quickly.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

15y ago

Valley flashing, if the dormer is a hip or gable roof, step flashing under the shingles which abutt the dormer walls.

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What kind of flashing is used on a roof dormer?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is an apron flashing?

An apron flashing is a term used for a flashing located at the juncture of the top of a sloped roof and a vertical wall.


When is step flashing used?

Step flashing is used in two applications on roofs. 1) Around skylights/roof windows (eg. Velux). 2) Around the base of chimneys.


What is a roof apron?

There are two meanings for a roof aprona flashing material, similar to a drip edge, that is installed at the bottom of a roof, channelling the run-off away from the fascia and into a gutter;a flashing along the edge of a roof where it butts into a wall that goes higher than the roof. The flashing directs water away from the wall and onto the roof.


What is 'lead pipes' not in architecture?

They ARE used when quality and longevity is needed for leader lines, roof drain flashing material


Where is flashing used on a roof?

it is used around the edges of the roofactually, it's used in the valley's and anywhere the roof meets an outside wall... drip edge is used on the edges, except in areas where precautions must be taken against ice-dams.Flashing is also used where anything passes through the roofA windowA stink pipeA flueA chimney stackA vent from a cookerA vent from a bathroom with no outside window.A drain in a flat roofIt is used anywhere there is a protrustion in the roof. Flashing can also be found around hvac units, scuppers, etc...


What kind of flashing should be used on the horizontal seam between two panel siding boards?

The horizontal seam between two panel siding loads should have what flashing?


What kind of roof designs should be used in cyclone prone areas and why?

if you can go to learn


Is a flashing kickout at the bottom edge of the roof or wall joint used to keep water from getting behind the stucco or siding?

Kick out" flashings are intended to prevent water from flowing behind a wall or down a vertical surface such as the fascia below a roof's edge by redirecting it a short distance sideways and onto a roof surface or into a gutter


What element is used bright flashing and advertising sign?

Neon is used for bright flashing signs such as advertising signs.


What kind of plants you get in Plants vs Zombies suvival roof level?

You get things like corn catapult, cabbage pult, melon pult. Things that are used in the roof level.


What is the DM800 Flashing used for?

DM800 Flashing is software used to help one view images. One has to add the DM800 Flashing to their browser first, and they are then able to view .nfi images.


How do you build 10 story house on sims 2 for PC?

You need to have Sims 2 University in order for this to work. Open the cheat bar (Ctrl + Shift + C) and enter the following cheat; SetHighestAllowedLevel [level] E.g. in your case it would be SetHighestAllowedLevel 11 Add one on to the number you want, so that you can add a roof too. Or You could add a dormer to your top floor and get an extra level if that doesn't work (It didn't work for me). In case you do not know a dormer is like a small part of a roof that has a wall and is commonly used for windows on loft rooms - The reason why it didn't work was because the cheat was entered wrong -