 |
What parts are needed and is it possible to swap trannys from a automatic to manual? |
[Edit] |
Answer
I'm actually swapping a 1989 auto s10 to a stick. It's a 4.3 v6 had a 4l60 auto trans and I'm replacing it with a 5 speed the bell housing has to match your engine the 4.3 is the same pattern as the small block v8. The auto flywheel has to be replaced with a flywheel the bolts up to a clutch & pressure plate etc. Matching year and motor size will make the job alot easier . My truck needed a hydraulic clutch so I had to remove the dash and install a clutch pedal with a master cylinder and slave cylinder on the trans. The body of the truck had to be cut out to accept the stick shift and the trans tunnel had to be hammered out to make more room for the bellhousing (minor differences in the case casting)
First answer by ID417613433. Last edit by ID417613433. Question popularity: 5 [recommend question]
Answers.com > Wiki Answers > Categories > Cars and Vehicles > What parts are needed and is it possible to swap trannys from a automatic to manual?
Our contributors said this page should be displayed for the questions below. (Where do these come from ) |
| If any of these are not a genuine rephrasing of the question, please help out and edit these alternates. |
