the steam strikes/enters the turbine th turbine rotats at requried speed.then it connected to genaretor ,the electricity genareted
Pre-commissioning and commissioning are words used in the engineering field. Pre-commissioning begins many months before the start of the project. During this phase duties are assigned.
you can take the car as sample before the car key has turn on, the engine is not running, you go to check the brake, windshield, tie, enigne, eletrical system....is installed well or not and the defect of component, this procedure is cold commisonning after you turn on, the engine is running, then you check again to detect the flaw. this is hot-commissioning you will always like to know the engine is installed well before you run it and make sure it run well the drive the car.
MECHANICAL MAINTENANCE,COMMISSIONING ERRCTION OF MACHINARIES,UTILITIES ETC Construction,errection,commissioning,and maintenance
Installation of a system or machinery up to the point of being able to start running is erection. Commissioning is preparing for running or taking into use of the installed system or machinery by making preliminary tests and checks (pre-commissioning) and initially running the system or machinery or taking it into use while checking and setting all of its running parameters in accordance with its design (hot commissioning).
in a radial flow turbine the steam enters the turbine in the direction of its radius and leaves it in the direction of the axis of the shaft. in a axial flow turbine the steam enters the turbine in the direction of the axis of the shaft and leaves the turbine in the same direction.
shal i get any book the same Every Commissioning has its way and steps. We use software for commissioning the BTS. Every Software tool has some steps. By following that steps, we can do commissioning
Pre-commissioning is the testing of non-energized systems. Commissioning is the testing of energized systems.
i dont know what it is either
Pre-commissioning and commissioning are words used in the engineering field. Pre-commissioning begins many months before the start of the project. During this phase duties are assigned.
There are huge types of BTSs. From 2G to 4G,various products using various methods. Commissioning is a procedure that add/modify different settings of BTS to provide access to its users. its done by Using PC with Access software's. either serial port or Ethernet port of PC used to gain access. But in BTS side it can be different type of connector. Procedure is different with each product.
Commissioning can be of any machinery, unit, or plant. So the commissioning of a power plant or steel plant is somewhat similar.Commissioning denotes the trials of the component individually, machines, and it's part individually and as a whole and later on, all combined together( commissioning of the unit). After the commissioning of each unit, the plant as a whole is commissioned.
can anyone furnish me the method statement for commissioning of FM200 Systems
commissioning mean adjustment, testing, and tuning.
you can take the car as sample before the car key has turn on, the engine is not running, you go to check the brake, windshield, tie, enigne, eletrical system....is installed well or not and the defect of component, this procedure is cold commisonning after you turn on, the engine is running, then you check again to detect the flaw. this is hot-commissioning you will always like to know the engine is installed well before you run it and make sure it run well the drive the car.
Power Advantage is the best service providers when it comes to Relay Testing & Commissioning.
asdsfsdafdsadsf
MECHANICAL MAINTENANCE,COMMISSIONING ERRCTION OF MACHINARIES,UTILITIES ETC Construction,errection,commissioning,and maintenance