The roller coaster was invented by Granville T. Woods and the first one was made of wood because his last name was wood.
The first Roller Coasters were made of wood. They were planks of wood attached to a short 1 metre chain lift in the centre. This was made of metal. By the way, if you didn't know, the first rollercoasters were made in the 1860's although these were controlled by only humans on their hands and knees working pulling ropes the make the car run. The first rollercoaster tracks were made of wood and sometimes metal.
Steel or wood. But the other type is hybrid, which is steel and wood.
the best material to make a roller coaster is small or tiny long pieces of railing, wiring and electricity but first you will have to know how or be an engineer
wood or steel, bolts
Yes, in the tracks and the wheels the roller coaster cart rests on.
Roller coasters are made from wood to metal depending on the ride.
They are called over the Shoulder restraints and are mostly used for looping coasters
Roller Coasters
The World's most strongest, the fastest and the scariest roller coasters is the hypersonic roller coaster, the underwater roller coaster, the twister roller coaster, the dinosaur roller coaster and the volcano roller coaster.
They are used for: Roller coasters, MRI scans, trains,refrigerators and etc.
The most used speed on roller coasters is 80 MPH, but a few go between 100-150.
there is 2 actually,there used to be three but they shut it down.....
clothoid/ klothoid
Glass coasters are a houseware accessory used to protect a surface from a cup, glass, or something other type of container that might sweat and leave a water ring on a table. A roller coaster is an amusement park thrill ride that might make you barf.
Electricity is used to power the electric motors that drive roller-coasters and also to apply the brakes at the end of the ride. It is also used to operate various safety features, such as sensors that operate the emergency brakes in the event of there being a problem with the track or the coaster cars, etc.
Wood does bend to form the loop. One wooden coaster used to they used steel for the loop. ^ that answer is really terrible and doesn't make sense....-.- they asked about INVERSIONS not one loop. there is a big difference between some simple loop and an inversion.