The timing chain and gears.
no
If you have a button about .005 to .oo8ths
327 sbc
The camshaft position sensor is located behind the intake manifold, on top of the block. It is difficult to get to, so be patient!
A bare Chevy 350 engine block weighs about 200 to 250 pounds. When you add in the crankshaft, camshaft, headers, and the intake it is more like 500 to 550 pounds.
Zora Arkus Duntov. That is where the old Duntov 30, 30, came from. It was a custom camshaft.
, the camshaft sensor for this particular application is located on the timing cover behind the water pump near the camshaft sprocket, it is inserted straight into the block with one mounting bolt retaining it. hope this helps
Lack of oil or it was damaged during installation. Was it pre-lubed before installing? If not, that is why it failed.
There is not a camshaft sensor on the '93 3.1 Lumina, just a crank sensor on the back side of the engine between the block and the barrel of the transaxle. Easy enough to get to from underneath the car.
two in the front, three on each side, and three in the back, though one of these is a plug for the back of the camshaft.
If you have the V-6 engine it is on the side of the engine block closest to the firewall just above the oil pan about 2 inches up and about middle of the block. This is the crankshaft sensor this car does not have a camshaft sensor On the 4 cylinder it is below the coil pack same side of the engine as the V-6. And again this is a crankshaft sensor not a camshaft sensor. Hope this helps
The camshaft is located inside the engine block.