answersLogoWhite

0


Best Answer
  • Pump assembly to case- (5/16-18) 15 ft/lb
User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What size bolt goes into the front pump of a GM th350 transmission?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What transmission goes with a 5.7 leter 1987 Chevy Silverado?

M38 (th350)


Will a turbo 350 transmission bolt up to a Chevy big block 454?

Any Chevy transmission will bolt to any Chevy motor. At least RWD. 1955 to current. A 454 should really have a 400 transmission but a 350 will work. Depending on what you are putting it in there may be an issue with the driveshaft length and the yoke that goes into the trans.


Where is the oil drain plug on a 2006 road king?

bottom front left corner of the transmission pan. It's a 5/8" horizontally installed bolt that goes in from the front toward the rear.


What transmission goes with a 5.7l engine?

If you have a Chevy 5.7 liter almost all Chevy transmissions 700r4 th350 th400 etc will fit. You can run a newer transmission 4l60e 4l70e or 4l80e basically they are electric overdrive versions of the older th350 and th400. the 4l60 and th350 is the half ton. The 4l65e is the corvette transmission and th400 and 4l80e is 1 ton. I believe the 4l70 is 3/4 ton and some half ton trucks like the ss and vortec max. the newer style transmission would need a stand alone controller which they sell and a aftermarket flywheel which will adapt the 2. Although all the bolt patterns are the same the 4l series one bolt on the top wont match up but its not a big deal and there are thousands of them out there. Your best bet is a beefed up 700r4 they can handle up to 450hp and don't need stand alone controller and have an overdrive. I would recommend a 2000 stall unless you have a rock crawler.


Where is the front seal located in the turbo 350 transmission?

It is located at the front of the transmission, on the pump. You can see it on the pump were the torq converter goes into the transmission. The trans has to be pulled out of the car to do the repair.


What transmission goes in a 1991 Lincoln lsc?

The 1990-1992 Lincoln Mark VII AOD is the only direct bolt up transmission for this car.


How can you tell when the manual trans is full on a 1991 Ford Festiva?

right rear of engine (looking at engine from front) where speedometer cable goes into front of transmission, remove retainer bolt and ubscrew speedometer unit, on side of unit is a small lever gauge. fill thru that hole.


How to check fluid for Clutch 1997 Mazda protege?

the part of the transmission where the fluid goes is on the drivers side part of the transmission. its right above the transmission temperature sensor and its the biggest bolt head right above the transmission temp sensor


Why might a transmission not shift into passing gear?

Usually that's the first sign of a transmission going bad.Overdrive sometimes goes out first.Also it could be a bad transmission sensor.A diagnostic check should tell you so.The sensors are cheap and easy to install. In older GM cars with the TH350 tranny, the "kickdown" cable could also be broken or not adjusted properly.


Can a transmission that goes to a 350 motor work with a 454 motor?

Yes if the bell housings match up to the engine bolt pattern.


Where is the transmission solenoids located on a 1995 Mercury Villager?

Remove the transmission pan and you will see them on the underside of the transmission. The cable goes up through the transmission case near the driver's side front wheel.


Your TH350 transmission only goes when you take it easy when you put your foot down it just revs?

If the trans is slipping when you step on it, you may want to visit your local pick and pull. First try smelling the trans fluid, if it smells burnt.....it is. If not try adding some fluid making sure not to over fill. This may give a little time, but I would strongly urge you to be on the lookout for a replacement TH350.