My 3 ton geo unit uses a 30 amp breaker. That is probably more than adequate because it also is for the vertical loop pumps in the ground.
The back-up heat strips however, use a 60 amp breaker (on my system.) I'm not sure but I would say yours probably needs that too.
Good luck!
The sizing of the circuit breaker and hence the wire size to feed the pump are all dependant upon the amperage of the pump. This question can not be answered without that information.
A breaker is based on the amperage that is drawn by the pump motor load. Find the full load amperage of the motor. The wire fed from the breaker has to be rated at 125% of the motors full load amperage. The breaker for motors have to be over sized, usually 250% of the motors full load amps.
60
Depends entirely on the voltage and current rating of your pump.
You need a 60 amp breaker.
Normally AWG #10 wire on a 30 amp breaker but it really depends on the size of the pump. The pump manufacture will specify the size wire and size breaker needed.
There are a few things you need to consider before purchasing a new heat pump. Should you buy a heat pump or should you choose a better choice, for example a furnace? What size heat pump will you need to buy? How efficient do you want your heat pump to be?
The sizing of the circuit breaker and hence the wire size to feed the pump are all dependant upon the amperage of the pump. This question can not be answered without that information.
A breaker is based on the amperage that is drawn by the pump motor load. Find the full load amperage of the motor. The wire fed from the breaker has to be rated at 125% of the motors full load amperage. The breaker for motors have to be over sized, usually 250% of the motors full load amps.
60
50amp but if considering the breaker cannot withstand starting current you need to size the breaker up.
Depends entirely on the voltage and current rating of your pump.
25 cubic feet
Contact Heatpro.
There are various factors which go into determining what size heat pump you need for a space. As a rule however, am 1100 sq ft house typically requires around a 3 ton unit.
You need a 60 amp breaker.
it is a 12 seer 4 ton heat pump