A belt-sander, with 60-80 grit belts. wear a respirator mask for sure.
ANS 2 - A belt sander will take forever, and hurt your knees. There are rotary floor sanders that you can rent. -Will do the job in 1/4 the time of a belt sander !
Use an electric heat gun and paint scraper tool. Hold heat gun at an angle facing away from you and not to close to the floor board. You want to heat the glue to make it soft not burn it. Hold the scraper at an angle and slide it under the glue. Scrape off the glue from the scraper onto a piece of angle metal screwed to a scrap piece of wood board.
Do not overheat the glue, you may start a fire. Keep a fire extinguisher handy. Remember some floor boards have gaps which contain dust fluff and other flammable material.
Take care its a messy and hot job.
Don't be tempted to use an old blowlamp or gas burner with an open flame as its almost certain to start a fire.
Rub it with Goof Off then slide a craft knife blade under it.
If it's still soft, just scrape off with a spatula. If hard,on old tile, soak them for a day, then scrape off carefully with a metal drywall spatula or broad wood chisel.
I wouldn't do it. Tar paper between subfloor and finish floor is a good technique, but gluing tiles directly to a tar paper surface is not a good idea.
hot glue gun would probably be your best bet
Yes, asbestos mastic (glue) under the tiles. ceiling or floor tiles?
Goof off will usually remove most self-adhesive glues.
Yes. In some but not in all. It is also found in the glue that hold the tiles to the floor.
Many 'adhesives' can be removed from concrete. Different ways for different compounds, use the remover that suits the glue.
YesANS 2 - I would only do that as a repair or an emergency. Floor tiles generally need a heavier and denser glue as they are being walked on - wall tile has no such stresses. ( -I have done lots of both types )
Not directly as the ceramic tiles will soon show through the vinyl flooring. If the ceramics are laid on a wooden floor, you must take up the tiles and overboard with 6mm plywood. If the tiles are on a concrete floor, you can leave them down and lay a latex screed on top to provide you with a smooth floor for your vinyl
It depends on which glue. Try Goof-Off first.
Yes, you can use wax.
Most glue is an adhesive such as Elmers school glue, puzzle glue, and wood glue
Remove duct tape adhesive with Goo-Gone or Goof-Off.