If you are making straight cuts, there are tile cutters that score the surface and then snap the tile.
If you will be making any semi circles or cut outs, you will need a wet saw. Also a wet saw is much quicker.
Ceramic tile should be cut with a wet saw, or with a tile scoring tool. It is not necessary to wet the tile in either case, as the wet saw will cool the blade and the scoring tool has no blade to cool.
Ceramic tile requires one to have not only power tool cutting tool experience, but also be proficient with math, his measurements, and planning. You can typically man the job yourself, but it is best to hire a highly trained expert for the field.
You will need a clean , level cement surface, mortar, grout, tile spacers, notched trowel and wet tile saw. Also, a bucket and stirring tool.
If these are ceramic ect; and they are solid ;leave alone. Depending on what you are going to replace them with;you could screed over joints ect with floor compound . If you have to lift them you could use a chisel or hire a small power tool with a chisel point.;but even then you could be left with rough floor and still have to screed. I your going to lay a vinly you might cover with ply this you would have to be fixed with rawlplugs/screws.
Saber saw ... plus a drill for a starter hole (or 4 corner holes).
Try a Rotozip tool with a ceramic cutting bit if your just cutting a hole . If your taking the wall out you can cut a line with the same tool then use a big hammer this will make less of a mess then just breaking the plaster with a hammer.
The heater can most likely not be shortened. If ceramic tiles were installed then they will have to be cut to expand the opening with great care. The tiles will have to be wet, and the right blade used to prevent shattering. This is cutting wet tile with an electrical tool so electrical shock must be considered.
The FEIN multimaster can be used for window renovation, floor coverings, furniture assembly, tile restoration, boat building, car repairs, to name a few.
When we removed old tile flooring we simply used the good old scraper. Not very effective but vey cost saving. You could alo rent something from Lowe's or Home Depot that will help speed up the process.
The answer here depends on how much ceramic you need to cut. * For small holes in ceramics, a hammer drill (about $80 US) is generally used. * For a few small cuts, edge trims, etc., a rotary tool (Dremel, for example, about $50) with a diamond disk (about $10) is excellent. * To cut a moderate amount of ceramic tiles, a circular saw (about $75) with a diamond wet/dry tile blade (about $30) is adequate. * For a large amount of tile cutting, for example to tile a typical bathroom or kitchen, a wet tile saw with diamond blade and steel guides (about $150) is essential. * To cut really big ceramics, a professional stone finisher / installer should do the job. They can cut to exact sizes, give shapes and edges that make the work attractive, and polish finishes to give the exact look that you want. Shops that work with marble, granite, limestone usually cut all kinds of ceramics, too.
unbolt it from the floor you need a special tool
You will need what professionals need to do it. Some of them are a glass remover tool which can be purchased at auto mobile stores. You also need silicone or super tile glue to stick the glass and of course you will need gloves to protect your hands.