0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Chevy cavalier sun visor wont stay in place?
Replace plastic bushing.
How do you replace 1997 prizm domelight bulb?
Remove the plastic housing with small slotted screwdriver. Gently remove the bulb vertically and replace with new bulb. Replace plastic housing until you hear it click into place
How do you replace a power driver side mirror from a 4 door Honda Civic?
Pull the triagular black plastic. The hook is in the center. It should come out easily. Then unscrew the three nuts. Remove the old mirror and replace with the new one and tighten the nuts. Place the triangular plastic back in place.
How do you replace a window in your aluminum sectional garage door it seems to just have plastic channels holding it in place?
In reality, by all means i do
How to replace side mirror on 96 quest?
You have to remove door panel to get access to the screws holding the inside plastic cover in place. Remove the plastic cover and then the three nuts holding the mirror.
How do you remove the rear accentlight on the rear door assembly - not the turn signal - on a 2004 sienna to replace a bulb?
I pulled the inside plastic cover of the rear door. Once it is loose at the bottom or lower edge you can reach up and replace the lamps. Then snap the plastic cover back in place.
How do you replace Honda Civic dx back window?
To replace the back window on a Honda Civic DX, you will have to remove the old one, peel off the remaining plastic, and put the new one in place.
What happens if you replace a bulb in a circuit for a piece of plastic?
The plastic might burn.
How do you replace tail lights in a 2005 Mercedes SLK?
open the trunk, remove the plastic cover assy, remove the required bulb, 1/2 turn and replace same. Replace plastic cover, by pushing the plastic rivits stright in.
How do you change the bulbs in your headlights for a 2002 Pontiac Sunfire?
two bolts on the top of the plastic housing - lift the plastic headlight out and unscrew the headlight from the bottom of the light- replace the bulb and be sure to get the plastic pins in the right spot before you bolt the headlight back in place.
What material would you replace with plastic?
glass
How do you repair plastic bull nose coping on an in-ground vinyl pool piece broken off where the winter cover snaps in?
Unless it is in a place where you can glue it and it will not be noticable I would try to replace it. If you have the piece you can use a plastic welder to repair it.
