0
12v switched source. such as headlight switch or dimmer on the dash.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What color wire do you connect to the dimmer wire from radio?
Don't connect the red wire or you will die.
When hooking up a new car stereo with a dash illumination dimmer what wires do i connect to make lights work?
Ford Taurus Car Stereo Radio Wiring Diagram Radio Constant 12V+ Wire: Green/Yellow Radio Ignition SwitchFord Taurus Car Stereo Radio Wiring Diagram Radio Constant 12V+ Wire: Green/Yellow Radio Ignition Switched 12V+ Wire: Yellow/Black Radio Ground Wire: Black/Light Green Radio Illumination ...Dimmer Wire: Light Blue/Red Radio Antenna Trigger Wire: Orange/Blue Radio Amplifier Trigger Wire: ...ed 12V+ Wire: Yellow/Black Radio Ground Wire: Black/Light Green Radio Illumination ...Dimmer Wire: Light Blue/Red Radio Antenna Trigger Wire: Orange/Blue Radio Amplifier Trigger Wire: ...
Do you need to wire the dimmer illumination wire if your new radio dont have it?
No. There is no illumination, speed or retained accesory power in the factory radio. It is accomplished with car's CANbus communication. To hookup illumination wire on 2006 VW Jetta, tap into white/black wire at the light switch. It dims your lights on your radio. You can also set up different color for day and night.
Why won't my dash lights work in my 1999 Chevy Malibu?
Check fuses, check dash light dimmer switch. Do your parking lights come on when you turn them on with your head light switch. Check for power to all.If you've just installed an aftermarket stereo then this might be the solution for you: On most aftermarket stereos there's no wire connection for the Dimmer and/or Illumination (or there's a hook up for either the Illumination or Dimmer wire) and usually most people just tape them off and push them back. Well in the Chevrolet Malibu all of the Instrument Panel (to include the factory stereo) are wired together so that if one wire is disconnected it all goes out. So in order for you to get your Instrument Panel lights working again you must splice the two wires together.In laymans terms, you have to connect the Dimmer wire [Brown (not striped)] and the Illumination wire [Grey (not striped)] together. If your problem was the same as mine then this should do the trick
How do you wire illumination wires on stereo?
You connect the positive one (commonly orange/white) to your dash lights positive.
Where do the orange wires connect on my stereo harness for a 92 regal?
orange wire is commonly the light/dimmer switch.
Where do you connect the orange wire in the car stereo?
I guess your talking about the dimmer it gets spliced into dash lights after switch.
Brake lights taillights turn signals dash lights dont work but head lights do on a 1997 Chevy S10 Blazer?
Replace your Head light switch. All of these circuits run through that switch.i just had this same problem but on my '97 Chevy Malibu... if you've just installed an aftermarket stereo then this might be the solution for you: On most aftermarket stereos there's no wire connection for the Dimmer and/or Illumination (or there's a hook up for either the Illumination or Dimmer wire) and usually most people just tape them off and push them back. Well in the Chevrolet Malibu all of the Instrument Panel (to include the factory stereo) are wired together so that if one wire is disconnected it all goes out... so in order for you to get your Instrument Panel lights working again you must splice the two wires together...In lamens terms.. you have to connect the Dimmer wire [Brown (not striped)] and the Illumination wire [Grey (not striped)] together.. if your problem was the same as mine then this should do the trickGood Luck!!!
Dimmer swicth cause dash lihgts not come on?
The dash illumination light (dimmer) switch could be in the off position.
Where is the Subaru Forester dashboard light dimmer?
On my 2000 Forester, the dashboard illumination dimmer control is on the turn signal stalk. --Ken
How do you install a tach on an '82 Chevrolet 305?
Its EASY! just connect the (usually green) wire to the negative post on the coil. Hook up the power wires and the illumination wire and ground for the tach wire and ur done its easy!
1989 Chevy 2500 why do lites on radio and ac show during day but turn on lites all dash lites go out?
The illumination of the dash during the daytime is at full brightness, normal. When the head lamps and such are turned on the brightness of the dash illumination is overridden by the dimmer. Turn the dimmer up. Usually rotation of the headlight knob will do the trick. Now if you have an electronic dimmer then it may have failed and will require replacement. Obviously the illumination works so the issue is the night time configuration of the lighting through the dimmer.
