DIRTY ICE MAKER WATER VALVE OR BROKEN VALVE
Most refrigerators in use today have ice makers that may stop working from time to time. The refrigerator’s ice maker receives its water supply from a water valve. The water valve is the first component of the refrigerator that should be checked when there is a malfunction with the ice maker. To operate, the ice maker closes an electric circuit enabling the water valve to open. Water will then flow through the water valve into the ice maker. The ice maker will then begin the process of making ice cubes and placing them in the ice tray. The water valve has a filter that keeps out particles from entering into the ice maker through the water supply. These particles can sometimes build up at the water valve filter and may even block the flow of water to the ice maker. When the flow of water in the water valve is restricted due to build up, it can cause the still water freeze in the valve. One solution is to heat the water valve with a hair dryer to melt the ice buildup in the ice maker. Be careful not to heat the plastic of the refrigerator too much causing it to melt. These particles can also lock the valve in the open position filling up the ice maker to excess. Sometimes an open solenoid coil winding can cause the valve to remain closed. This will not allow the water to flow to the ice maker as the plunger remains closed. In order to do further tests on the refrigerator to determine the fault with the ice maker is to test the current flow. This will not only be a safer measure for you as you attempt to repair your ice maker, but will also ensure the various components are operating as they should. Your diagnosis will most likely be related to the water valve, but if your refrigerator is old it could mean your ice maker needs to be replaced. Occasionally the electrical connections can sometimes get short circuited or disconnected during use. Thoroughly examine all the parts of your refrigerator with the proper tools and testing equipment.
Check the water line.
A meteorite can land in some sort of water source and it can cause the water source to overflow.
too much water added the overflow is designed to let out water.onece the radiator reaches the required pressure,the excess water is exhausted thru the overflow
Water flowing out of the freezer is a common problem usually caused by a blocked defroster drain. Another possible cause is a failure in the installed ice-maker or water dispenser. And don't miss the obvious: perhaps someone spilled something and failed to clean it up.
I've changed the Ice maker and the wated controler on the back of the Frige.... But when I turn the Ice maker on nothing happens. It's been on several hours now and no water has filled the the resovoir. I am thinking that the device should rotate and will release water into the resovoior. Is this correct or should water flow in once it's hooked-up?
because the entire point of the overflow resovoir is to overflow, and release uneeded water
The water line where it enters the ice maker could possibly be frozen.
Check the water solenoid valves. On our Kenmore the valves had begun to stick causing the ice maker to fail as it is a timed cycle to fill the tray.
That would be your flush valve in the tank
The ocean would probably overflow and cause a flood to occur.
Because the explosion can cause overflow of water causing harm to users and surrounding environment