Hey Barbara==It could be as simple as a blown fuse. Check ALL of the fuses. Goodluck, Joe
Chrysler tied the cigar lighter fuse in with the park lamp circut go to the cigar fuse and replace it and it will be tadah, dash lights.
I had the same problem on my 91 convertible. Checked all fuses and replaced, still not working. I ran a hot fused wire under the console and attached it to the hot line for the cigar lighter. Horn and lighter now work great.
Hello there, I have a LeBaron Sedan. If neither the dashboard or the horn works, maybe it's a fuse the cause, or perhaps your electric system has a short circuit issue that you must attend before more electric-related systems fail. That's what happened to my car about ten years ago; first the radio when out, in a month or so after that the dashboard, later the directionals. If the fuse replacement doesn't work for your car problem, feel free to contact me at alg11@televicable.net.mx
It could be the horn relay located behind the drivers side kick panel next to floor or you can check it by turning the ignition on and pressing on the Two horn buttons and listening to see if the relay clicks as you press the button. If it doesn't click the horn relay needs to be replaced. Note: There are 8 or 10 relays on this relay block so you must use the diagram located on the backside of the panel that covers the lower part of the steering wheel.
There could be a few things on a 1995 Chrysler LeBaron causing the distributor not to have power. But first I would check the spark plugs and see if maybe they have gone bad.
it seizes thru lack of use... overhall it..
The Lebaron was no longer in the lineup for Chryslr in 2006. The Chrysler Lebaron was produced between 1977-1989,and was then phsed out by Chrysler due to weak sales.
The last Chrysler LeBaron was in 1995. Both engines available that year had timing belts.The last Chrysler LeBaron was in 1995. Both engines available that year had timing belts.
FIRST I WOULD CHECK FUSE MAYBE BAD USE A]> FUSE TESTER AN GO FROM THERE ARE AS SOMEONE AT PART STORE TO CHECK THEM ?
Most would beMost would be
You will find it (the PVC valve) in the same place as you would on a 1995 Lebaron 3.0. I own a 1990 Chrysler lebaron 3.0 v6 and found the PVC valve in the same spot. Look up where to find the PVC valve on a 1995 lebaron 3.0 on this site. Best of luck.
no but they may have broke a wire or disconnected a wire and not hooked it back up
no
you have to push down on the tension pulley, then you would get slack in the belt
There could be a few reasons why a 1990 Chrysler Lebaron will crank but not start. The fuel pump could be out or the car could be out of gas. There may be a malfunction in the ignition system causing no spark.
Knowing the way Chrysler often interchanges parts from many different cars, I would assume it would be about the same.