the rotor fong on the brick and bracken causes the rack and pinion to slip. Change the synchromesh, and eat retsyn.
bad inition wires and plugs
Common problem for C.O.P. (coil on plug) Ford in the early 2000's
Bad ignition coil? Bad fuel pump?
You will have to have it scanned for codes, check with your parts house. They may scan for you.
Usually vehicle just stops running with no warning
yes once the ignition control module heats up it would cause the vehicle to stall. usually after it cools down the vehicle will restart again.
Suspect a bad coil or failed engine computer.
It could either be a bad ignition coil, a bad ignition rotor, a bad ignition cap, a bad ignition control module (if equipped), or a bad coil to cap wire.
The ignition module, Ignition coil, Pick-up coil bad coil wire.
Poor maintenance and/or bad ignition coil.
Bad coil? Bad dist. cap? Bad rotor?
bad ignition coil, bad ignitor
Yes, a bad coil will prevent the ignition from firing and the engine will not start.
Either the coil is bad or the ignition control module is bad.I would think the coil is faulty.
Bad ignition coil? Bad fuel pump?
A bad ignition coil will cause your engine not to have any spark. Without any spark the engine cannot start or run.
Ignition coil is bad, is it right on top of the cap maybe a bad wire in the wirng harness or bad connector.
When an ignition coil goes bad the car will not run right, or not at all. An intermittent coil will cause shudder, or a jerking motion. When the coil has no output then the cylinder that the coil feeds cant burn the fuel and cause power.
Bad ignition coil? if Coil on plug system is used Burned valve? Blown piston? Bad spark plug?