the flush mountain inductive sensors got done up the bum by mount everest
A purely resistive load is one in which there is no capacitive or inductive reactance. Whe driven by an AC voltage source, such a load will have no shift in phase angle between voltage and current.
Resistance load it means there is passive load to impede current flow. Inductive load means there is a coil as a load while still a passive it has its own characteristics which differs from a resistive load which is linear while inductive is not linear load
Inductive sensors use a magnetic field to detect objects. Capacitive sensors use an electric field. In order to be sensed by an inductive sensor an object must be conductive. This limits suitable targets to metal objects (for the most part). In order to be sensed by a capacitive sensor the target doesn't need to be conductive. A capacitive sensor will react to an object acting as a dielectric material as well as a conductive object. This makes metal and non-metal objects suitable targets.
A capacitor is a device that resists a change in voltage, proportional to current and inversely proportional to capacitance. dv/dt = i/c An inductor is a device that resists a change in current, proportional to voltage and inversely proportional to inductance. di/dt = v/l In an AC circuit with capacitive loading, the current waveform will lead the voltage waveform; while with inductive loading, the current waveform will lag the voltage waveform.
Resistance is a concept used for DC. the current through a resistance is in phase with the applied voltage Reactance is used for AC the current through a inductive reactance lags the applied voltage by 90 degrees. the current through capacitive reactance leads the applied voltage by 90 degrees. the net reactance is the difference between inductive and capacitive reactance
The power factor (cosine of phase angle) of pure inductor is zero because the phase angle between current and voltage is 90 degrees .If the value is substituted in the formula It will be zero.
Voltage and current will be in phase for a purely resistive load. As a load becomes more inductive or capacitive, the phase angle between voltage and current will increase.
when a resistive load is applied there is no phase angle difference between voltage and current. when a inductive load is applied there is phase difference between voltage and current. current lags voltage by an angle of 90 degrees for pure inductive load
In electrical or electronic circuits, impedance can be said to have capacitive or inductive components. Capacitors cause capacitive impedance, and coils (chokes, transformers, loudspeakers, etc.) cause inductive impedance. A capacitor is said to be a reactive component in an AC circuit because it holds charge, then releases it, causing a phase shift in the output current. This phase shift in current equates to a phase shift between current and voltage. Reactive power is defined as a phase shift between current and voltage.
Yes, watts is still volts times amps, for both ac and dc circuits. The complexity lies in the phase angle between voltage and current. If the circuit is purely resistive, the phase angle will be zero. If the circuit is capacitive or inductive, the the phase angle will vary, depending on frequency and on how much capacitive or inductive reactance there is. The difference comes into play when you consider true versus apparent power.
When the circuit is purely resistive or in resonance, i.e. capacitive and inductive reactance cancels out.Power factor is the ratio of apparent power over true power, and is the cosine of the phase angle between voltage and current.
A lagging power factor is caused by inductive reactance, which is composed of resistance and inductance -- and the resistance component lowers the supply volts. A leading power factor provides capacitive reactance that actually helps improve source voltage -- this helps motor loads run cooler.