NO, not really but in order to get mine out I had to cut it.
AnswerAFTER THE TWO SCREWS ARE OUT, PULL UP, THERE IS A CLIP BEHIND IT.New Answer
If I remember right when I took mine out. There is a third screw at the bottom holding it in place. I had to take the grill off the get a socket on it.
after removing the reservoir gently pry out the old pump and lube the o-ring for the new one with lite oil
there is just one bolt toward the radiator remove that and then remove the electrical connection and you can lift it will pop out
The windshield washer pump is located on the water reservoir. You access the reservoir by first, removing the driver side wheel. Then remove the cowling around the wheel well that is in front of the wheel. This is tricky because it is held in place with plastic push-in screws and metal screws. This section of cowling paritially wraps around the the front of the car, under the bumper. Once it is off, which should take about 30 minutes, you will see the washer reservoir and pump very clearly.
Remove the two obvious screws from the top and filler neck. There are two more screws in the front of the reservoir that fit into recesses that are molded into the reservoir. That is why the reservoir seems loose but still will not come out. To access these screws, remove the turn signal\parking light assembly by removing 4 Phillips head screws. Use a light to help you see two 1/2" head bolts recessed in between panels of sheet metal. One is right at the top edge of the opening so you may have to shine your light slightly upwards. Use a socket and short extension to back these screws out. You do not have to remove them, just back them out about 1/2". Your reservoir will now slide out easily.
The washer solvent reservoir comes out from the bottom - which will likely involve taking the passenger side front wheel off and pulling back the wheel liner. Use the "Related Questions" below about the washer pump as a good starting point - add in removing the mounting bolt up on the inside fender and the reservoir should fall into your hands.
Removing a spare tire is easy to do from a Chevy Suburban. The tire is removed with the tool that is located on with your jack.
Begin by removing the hose from your windshield washer pump. Remove the windshield washer pump wiring harness. Remove the windshield washer pump retaining bolts. Reverse the process to install your new windshield washer pump.
"When using an insulin pump, the reservoir needs to be filled with insulin. You do this by drawing insulin from a vial into the reservoir with the plunger, and then removing the needle."
Changing windshield wipers is not a difficult task. Most replacement windshield wipers come with instructions and it's usually as simple as removing the old wiper and inserting the new one.
Yes it will. Your engine will not run properly and you will get poor mileage and loss of power. And besides that is it a federal crime to remove the catalytic converter from any vehicle.
You can remove the windshield washer fluid tank from your 2001 Chevy Cavalier by removing the retaining bolts. There will be for retaining bolts at the bottom of the windshield washer fluid tank.
The windshield wiper motor is under the front cowl. After removing the cowl the motor should be easily accessed for replacement.