0
Where can you obtain a gasket or 4 position vari-flo valve for an old Hayward sand filter SP 704?
Wiki User
∙ 16y ago
You could try poolcenter.com
ANSWER::
And the problem begins. Do you have the right tools for removing the valve parts? Some valves require specialty tools. Another problem is how do you seat the "spider" gasket. Most glues, caulking compounds do not hold. It may be less expensive -- cost effective -- in time and frustration to replace the entire valve. Even the manufacturer will balk at revealing the glue that they use. Also will you be able to get the gasket seat clean or dry enough?
A pool store may be able to special order the spider gasket. Expect to wait a while.
K
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you replace an oil filter gasket in a 3.8 2001 Ford Windstar?
The oil filter gasket is built into the filter itself, so just by changing the filter, you always get the new gasket.
What is an oil filter gasket?
An oil filter gasket is the rubber seal at the bottom of the oil filter that seats on the engine.
How do you change the oil filter on a 84 Porsche 944 is there an extra gasket under the filter?
Remove the old filter and make sure you remove the old gasket, there should only be 1 gasket.
Oil filter gasket?
The oil filter gasket is a rubber ring that is usually bonded to the oil filter. If the oil filter has been removed and has no gasket, then it has become stuck to the engine block. Remove the gasket from the block before installing a new oil filter with it's own new gasket. Be sure to spread a little clean engine oil on the rubber gasket before installation to help seal and prevent sticking to the block. Do not overtighten the filter, turn the filter until the gasket contacts the block and then tighten 1/4 turn more. If the gasket leaks, tighten just enough to stop the leak.
How do you place oil filter gasket 2000 expedition?
When you replace your oil filter it come with a new gasket. Just make sure when you remove / replace the old oil filter the oil gasket comes out with it.
How do you change oil filter gasket on 86 Honda accord?
The gasket comes preinstalled on the new filter. Make sure the gasket comes off when you remove the old filter. Apply a think layer of oil to the new filters gasket before installing.
98 ford mustang gt --how do you change an oil filter gasket which attatches to the block between the block and the filter?
the gasket comes built in with the oil filter period! there arent any gasket except the one on the filter . find a new mechanic!
How to replace gasket on oil filter base on a 1994 Mercury Cougar?
Gasket should be included with new oil filter
Why does the pressure in my Hayward DE filter lose Pressure so quickly?
Have you maintained the water level in the pool? Could be a suction leak. Check the pump lid gasket for correct fit. Have you emptied the pump or skimmer baskets lately? Ken
Where is the oil filter seal?
On the filter. The open end that you screw on has a gasket around the outer edge. Oil the gasket before installing.
What would make the oil come out the oil filter?
Oil coming from the oil filter area usually means that the gasket for the oil filter is not seating right. If the filter was changed recently, the old gasket could have been left on, along with the new gasket, causing a bad seal.
How do you change gasket on oil filter housing on 97 grand marquis?
Your 1997 Mercury uses a spin on cartridge filter. The gasket is built into the filter. Just apply a thin layer of oil to the new filter gasket and screw it on. Tighten 3/4 turn after it makes contact with the mounting surface. Do not over tighten. If the old gasket was left on when you removed the old filter just pull it off.
