On top of the intake in front of the throttle control. it has a two wire plug going into it.
IAC sits on the top of the motor.
no have , per wiring diagram.There is no IAC motor for this engine and I suspect you have an error code
A bad IAC (Idle air control valve) or a vacuum leak or both.
At the base of the throttle body.
iac valve...idle air control valve
PvHNPI csvhqbbekdtw
Its on the back of the throttle body.
Because the IAC valve is faulty.
The Idle Air Control (IAC) valve is mounted on the throttle body
The IAC is located on the passenger side of the throttle body toward the rear. It screws into the housing using a 1" wrench.
REMOVAL & INSTALLATIONFig. 2 Detach the connector for the IAT valve and ...Fig. 3 ... remove the retaining bolts for the IAC and ...Fig. 4 ... lift the IAC valve off of the engineFig. 5 Remove and replace the gasket with a new oneFig. 6 Thoroughly clean the mating surfaces of the IAC and the engine# Disconnect the negative battery cable. # Remove the air cleaner inlet tube and the throttle cover, if necessary. # Disconnnect the wiring harness from the IAC valve. # Remove the two retaining bolts. # Remove the IAC valve and discard the old gasket. To install: # Clean the gasket mating surfaces thoroughly. # Using a new gasket, position the IAC valve on the throttle body. # Install and tighten the retaining bolts to 71-106 inch lbs. (8-12 Nm). # Connect the wiring harness to the IAC valve. # If removed, install the air cleaner tube and throttle cover. # Connect the negative battery cable.
The IAC (Idle Air Control) valve is faulty.