The encoder motor sensor is found inside the front of the transfer case. The sensor motor assembly is removed with 3 - 15mm bolts after the front driveshaft and electrical connector are disconnected. The encoder motor sensor is under the big gear on the back of that assembly plate.
The MAP (Manifold Absolute Pressure) Sensor on a 2000 Chevy Suburban is located on the very top of the motor. It is all the way to the back of the motor. There is nothing behind it.
The 4wd message in a Chevy Suburban is most commonly caused by the encoder motor or the selector switch failing. The transmission computer codes should be run to see if an indicated.
hi this is peter i have a 2001 chevy blazer and how do i change the encoder motor on the transfer case? thanks
at the beginning of the air filter(air box) closest to the motor
Yes.
The anti-lock brake system in some vehicles can malfunction and cause an your motor to lock up.
You need to remove the front drive line, remove the encoder motor assy. On the bench remove the motor and plate together to expose the gears, mark the gears with a sharpy and remove the big gear, the sensor is on the bottom. plug in new sensor and reverse to assemble.
An encoder motor is the part that engages the change between 4wd and 2wd.
where is the camshaft sensor on a 2000 Chevy sliversdo with a 4.8L V8 motor
Just took it in to dealer for a 2003 Avalance 4WD. 3.5 hrs of work plus encoder module. $450.00
Were is the temperature heat sensoe on a 454 chevy motor.
The horsepower rating on a 1986 Chevy Suburban with a 350 motor is between 180 and 200. This allowed these sport utility vehicles to perform well when weighing in excess of 5,000 pounds.