I had a 1997 2.5 GT. It was on the top of the engine block, towards the firewall, but you had to remove some of the air intake system at the top of the engine to see it.
The 1997 Saturn knock?æsensor is located on the back of the engine. The knock sensor can be removed by removing the wiring harness and the retaining bolts.
The knock sensor is located below the intake manifold
Yes, there is a knock sensor on the 2.3L. It is located on the rear driver's side of the cylinder head.
The Chrysler Sebring knock sensor is located in the engine valve or cylinder located at the back of the motor. This part is in this position next to the engine valve so the sensor can feel the vibration of the engine.
underneath the window
The knock sensor, in your 1997 Chevrolet Lumina, can be found on the front of the engine. The knock sensor is near the top of the engine.
On the back of the block, below the intake manifold.
location of knock sensor in 1997 cheverolet Tahoe SUV 305 or 350 engine
the Knock sensor is located behind the Harmonic balancer pulley. on the bottom sidethe sensor is $95.00 remove the lock down screw unplug and replace
center of the engine near the top. It is going to be by the heads.
One Sensor.... Removal Procedure 1. Remove the intake manifold. 2. Disconnect the knock sensor electrical connector. 3. Remove the knock sensor. Installation Procedure 1. Install the knock sensor. Tighten the knock sensor to 19 Nm (14 lb ft). 2. Connect the knock sensor electrical connector. 3. Reinstall the intake manifold.
It's screwed in the side of the engine facing the firewall.