answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Where is the accessories aka ignition wire for installing a new stereo into a 1985 jeep cj7?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

When was Stereo MCs created?

Stereo MCs was created in 1985.


Why would your 1985 Ford Mustang 50LX stall while driving and after installing a ignition coil?

It mostly is your neutral safety switch i had the same problem good luck


How to drill out ignition switch on 1985 Ford F-150?

How to drill out ignition switch on 1985 ford f150?


How do you install a stereo in a 1985 Honda Accord?

To install a stereo in a 1985 Honda Accord, make wire to wire connections using either a solder iron and electrical tape.


How do you install a radio in a 1985 Holden Astra?

firstly take out the old stereo.. using a voltameter find the 12v supply cable.. this should always be on even when ignition is off then find the accessories power cable with the ignition turned to on. hook up the earth cable on any metal surface in the car use a 6 volt battery to find the speaker cables go thru the wires until you hear a "pop" sound and this will indicate which speaker is from which wires. hook up all wires (for a better installation solder the wires and cover with tape but if you cant sodler just twist together and tape) and replace stereo in the dash.


Where is the ignition fuse located in a 1985 Chevy Impala and which fuse is it?

The ignition is not fused.


Where is the horn relay located on your 1985 corvette?

on mine its behind the stereo....


How do you switch out ignition switch on a 1985 c10 Chevy pickup 4x4?

Remove the retaining ring at the top of your 1985 Chevy ignition switch. Slide the ignition switch out and remove the wiring harness. Reverse the process to install the new ignition switch.


Where is ignition module 1985?

Lincoln continental yes.


Where is the ignition module on a 1985 Pontiac 6000?

On the distributor.


How do you take out 1985 Ford Tempo stereo?

with "ford radio removal tool"


How do you remove a 1985 Chevy El Camino Ignition switch?

The 1985 Chevrolet El Camino ignition switch can be removed by loosening the retaining ring at the top of the switch. The switch will slide out. Remove the wiring harness from the back of the ignition switch.