Look behind the bumper, on the driver's side of center. It will be held up by a cable tie, if it's never been used before.
The 1997 Geo Tracker block heater does have a frost plug. The Frost plug will be a few inches below the block heater.
Why wouldn't there be? You specifically ask about a 250... as if you know why there is one on a 350... and so on.. If you do, the answer is the same. If you do not, why didn't you ask why there is a block heater plug on diesels in general..
It is located just above the starter, which is on the passenger side of the truck.
i have a 2002 f250 and mine is inside bumber down around fog light area.
Drivers side of the engine above the oil filter. Or check inside the front bumper (driver side). Look inside the front tow hook blockout for the plug. There should be about 6" of cord tucked inside.
Block heaters work the same as the heater element in an electric kettle . The power comes from an electric outlet in your home etc. so there is no fuse on the vehicle for the block heater . The most common problem is a break in the block heater cord wiring just near the male end that you plug in to the electric outlet
plug a block heater plug into any household 120 electrical outlet just like plugging in a heater in your house
The 1995 Cadillac block heater plug can be found on the right hand side of the engine. The block heater plug will be near the back of the engine.
where is the heater block on a 2004 saturn vue?
The best solution is to purchase and install a clamp on block heater which is available through a Suzuki dealer. To my knowledge, you can't install a normal type of block heater (installs in frost plug). Dave Saskatchewan Canada 96 Suzuki Sidekick Sport
Remove and engine block expansion plug. Insert the block heater. Seal the block heater. Attached the wiring harness to the block heater.
The block heater plug on a 4300 International truck is located just behind the battery. A heavy duty outdoor cord will be necessary to plug the block heater into an electrical outlet.