It is located just below the glove box, forward of the dash, and is fastened into the the blower motor case. It may be seen by looking under the dash as well as by removing the glove box. No tools are required to remove the glove box. The electrical connecter to the blower motor resistor is rectangular in shape, and is oriented horizontally. The hardest part of removing the resistor is unplugging the connector.
Resistor is located behind the blower motor assembly.
where is the location for a blower motor relay on a 2006 ford freestar
The blower resistor controls the speeds of the blower motor Hi-resistance lower motor speed Lo-resistance higher motor speed
# Locate the blower resistor under the right-side of the instrument panel # Disconnect the electrical connector from the blower motor resistor # Remove the blower motor resistor mounting screws and remove the resistor from the housing # Installation is the reverse of removal
They generally locate the heater motor speed resistor nearby the blower motor because the resistor depends on the blower to keep it cooled.
Blown Fuse, loose or disconnected wire, or defective blower motor resistor pack.
The heater resistor coil is located on the blower motor on the 2006 T300 Kenworth.
blower motor resistor needs to be replaced
blower motor resistor
Could be, blown fuse, bad blower motor, bad blower motor speed resistor, bad blower motor switch,
The blower motor speed resistor is burned out.
The blower resistor has failed. Located behind glove box door.