0
is this a 3rd gen or a 2nd gen???
if its a 3rd gen the coolant reservoir is on the same side of the car as the turbos are located, underneather the main headlight.
believe its a similar location on 2nd gens.
cheers.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Do you fill a coolant tank on a Mazda Astina with water?
I believe that you fill it with coolant, as the tank's name suggests.
How do you drain 1991 ford explorer coolant reservior?
Actually , what I did was go and buy a cheap plastic turkey baster and used that to suck the coolant out of the tank - it took less time than I figured
Where is the fuel pump on a 1992 Mazda Protege?
In the gas tank.
How do you change a Mazda rx8 coolant tank?
remove the two 10mm nuts. dissconnnect the coolant level sensor plug and remove coolant hose's
What is the gas tank capacity for a 1992 Mazda Navajo?
19.3 gallons
Where is the fuel pump on a 1992 Mazda MPV located?
inside the gas tank
Where is the location of engine coolant sensor on 2004 Mazda RX8?
It is in the coolant expansion tank Problems with this sensor are common as they are pourous and take up coolant, eventually sinking and bringing on the coolant check light. You most likely will need to change the coolant expansion tank to cure the problem as it is usually sold as a unit. Kev
Where is the fuel pump located on a 1992 Mazda B2000 Pick up Truck?
in gas tank
Where is the cooling sensor located on a 1998 Chevy Cavalier?
IF you're asking where the coolant level sensor is located, it is located inside the coolant reservoir (that plastic tank on the passenger's side under the hood). The electrical connection is toward the front of the reservior on the engine side.
If engine gauge does not show overheating but coolant spews from overflow tank what is the problem in a 2001 Mazda MPV?
Thermostat may not be opening
Why does the Coolant warning light comes on when radiator ant tank are at the correct level Mazda RX 8?
The RX8 has a common problem with the coolant level sensor in the expansion tank. Unfortunately the sensor is part of the tank and so the whole unit needs to be replaced, a fairly easy job to do!
Where would a ball cock be used?
In a toilet tank or water reservior to regulate filling.
