On the engine.
It depends on what engine you have. I have the Dt466 engine in mine and my MAP sensor is located on top of the valve cover towards the front of the engine it has a three prong pigtail on it.
Disrupt the frequency of the signal from the speed sensor to the ECM.
nothing
I have the DT466 in a 24' van. Use it lightly loaded, normally about 8000 pounds tops, and we get 9 MPG.
29 quarts
DT466 is an inline six cylinder diesel motor manufactured by Navistar International. It's a 7.6 litre (466 cubic inch) motor, rated between 210 and 300 horsepower. It was superseded by the DT466E in 1994, which introduced electronic controls to the motor, although the badges on the side of International vehicles did not reflect this change, and still simply said "DT466". As of 2007, the DT466 was redesigned to meet the 2007 emissions regulations, and is now produced and marketed as the MaxxForce DT.
The fuel stop solenoids on a DT466 are actually three wire types. There is a ground wire, a pull-in wire, and an ignition wire. It will be on the main engine harness just above the pump.
115 ft pounds
A little over 1400 lbs
32quarts (8 gallons) w/ filter
Yes they have the same block . it's the mid plate you can change
repair manuals for a 2001 international dt 466e model c195