Where is the fuel filter located on a 1988 Toyota truck?

Answer 1

from 20r & 22r RE who cares same thingdifferents for 20r's 22r's not muching its just the dual chain and single dual is pop up pistons and single is flat top..................the answer for ur question is go 2 Napa, Auto Zone, Pep Boys, were ever parts place......get a fuel filter and just get a cheap 1 works the same and u might have to buy a small hose w/small claps less than 25bucks total and u wont have to break ur neck looking for those lines even if its EFI its not a car its u don't have to buy a intank fuel pump.....the 22r 22re 22fi doesn't need that much PSI for the EFI like other vehicals u don't need goodluck it will work......if ur back glass or front windshield cracks 84-95 will fit BOTH front and rear........beds exrta cab and single cab beds will fit not like Mazada trucks or Nissan 4x4 or 2WD it doesn't matter..........84 and below Celica is the same motor trans will fit too 84 supra the trans only will fit.....V6 Toyota Trucks 4.56 ratio 4x4 or not...V6 AT 4.88ratio.....4x4 4cyl 4.10-4.11 ratio.....dual rear 4.38ratio..(84-95 4runners rear ends "ratio" will work too)...now for 5.29 and 5.71 I'm not telling have a good day and remember its not luck it will work remember if u have 2WD and u want 4x4 raito u need the whole axle its a 8.0 and the 2WD is 7.5..........I know its kinda too much info but I just love to help others and tell some small secerts here and there and since ur name is Mike well thank me later........671GUAM671...Michael671

Hey Mike==It is inline. Get under it and follow the fuel line from the tank to the engine and you will find it. GoodluckJOe

On my 88 Toyota truck, you reach over the front passenger wheel to access the fuel filter. It is tough to get at, but two bolts hold it on and it is locate up and back from the oil filter. .

Like he said, crawl underneath and follow the lines from the tank, it's located on the frame rail.....

This is correct, the fuel filter is bolted to the engine block my truck is EFI, the filter is hard to get to I had to go in between the fender well and upper A-frame to get to it. The bolts that hold to inlet and outlet lines are metric 17 and the two bolts that secure the filter to the block are metric 12.{ I GOT IT OFF , BUT ITS GOING TO BE HELL GETTING A NEW ONE BACK ON }

Hi,

On my 1988 (22R engine, short wheelbase, 2 wheel drive model) it is located in front and above the fuel tank on the right hand side of the truck, the way I change mine (it is a messy job) is to lay under the truck on the passenger side and reach up past the filler hose and there is the filter.

On the righthand side of the block,just under the intake manifold and behind the starter. It's easy to get to if you remove the right front wheel and go in from the fenderwell.