Where is the fuel filter on a 1991 through 2001 Ford Explorer all models?

Answer 1

Location:

Under the vehicle driver's side on the frame rail under the driver side door. There is frame right underneath it but you can access it easily. Be sure to release the fuel pressure before changing the filter. The fuel pressure release valve is located in the engine compartment on top of the engine. It is on the left side of the air intake manifold. It is just a small cap over the valve. Be sure not to lose that cap!!

When you change the filter, the filter line on each side of the fuel filter has a quick disconnect type fitting inside the line (similar in principle to a quick disconnect on a gas line or air compressor line). To free the filter from the line you must push in (toward the filter) with a simple tool you can purchase at most auto parts stores for just a few dollars.

Additional Information:

The tool I was able to rent from NAPA. The guys there were very good to me. Look for about 45 min. of time to complete replacement.

____

First off you're going to need to relieve the pressure in the system, and if you think you're going to just pull the fuel pump relay and then run the engine until it stops to relieve pressure it ain't gonna work. Get a bleeder gauge. You're also gonna need a quick disconnect tool. Ford models are usually 1/4" 3/8" or 15/16". Put it on the fuel pump right before the "duck bill" then try to push the line forward. If that doesn't work, just try to push the tool into the duck bill then try to push the line forward.