 |
Where is the ignition module located on a 1995 Mercury Sable and how do you replace it?In: Mercury Sable |
[Edit] |
Answer
Look at the distributer. There will be a module on the side that is either grey or black, and is about 3 inches long and 1 inch wide. It is held onto the distributer with two 7/32(5.5 mm) screws back inside of two holes on the module. You will have to get a thin wall socket to access them. I use a 1/4 drive deep well Sears Craftsman socket to get them off. NOTE: 7/32nds inch and 5.5MM are the same size, so either will work.
First answer by Wvafan. Last edit by Wvafan. Contributor trust: 678 [recommend contributor]. Question popularity: 11 [recommend question]
|
Research your answer: |
- Why wont my turn signals and flashers work. i tried new fuses.it a 1997 mec. sable wagon.it sat four 4 years.?
- When trying to set cruise control on a 1999 Sable why will it blink but not engage?
- On a 1999 Mercury SablewWhere is the switch located that cuts off the cruise control when the brake is applied?
- What is the cost to replace fuel pump on a 2002 sable?
Answers.com > Wiki Answers > Categories > Cars and Vehicles > American Cars > Mercury > Mercury Sable > Where is the ignition module located on a 1995 Mercury Sable and how do you replace it?
Our contributors said this page should be displayed for the questions below. (Where do these come from ) |
| If any of these are not a genuine rephrasing of the question, please help out and edit these alternates. |
