answersLogoWhite

0


Best Answer

on the passenger side of the block behind the moter mount.

User Avatar

Wiki User

17y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the knock sensor for a 1995 camaro located?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the knock Sensor on a 1995 Mazda B4000 truck V-6 4.0?

I don't think it has a knock sensor ( I know that the 4.0 liter V6 engine in my 1995 Ford Explorer doesn't have a knock sensor )


Where is the knock Sensor on a 1995 Mazda B4000 truck V 6 4.0?

I don't think it has a knock sensor ( I know that the 4.0 liter V6 engine in my 1995 Ford Explorer doesn't have a knock sensor )


Where is the knock sensor 1995 cadillac deville 4.9 v8?

there is no knock sensor on 4.9l V8 motors


Where is the knock sensor located on a 1995 Sierra with a 5.7 engine?

near the oilpan, on the side of the motor, towards the bottom.


Does a 1995 Chevy Camaro Z28 have a crank sensor?

No it does not


Where is cam position sensor located on a 1995 3.4 Chevy camaro v6?

Behind the motor and down about 2 inches.


Where is the knock sensor on the 1996 Nissan Altima?

Knock sensorThe knock sensor for a 1996 Nissan Altima is located on the backside of the block above the oil filter.But before you go and change it out, run a tank of the best/hightest rated gas you can find and see if that fixes the problem. On my 1995 the Knock sensor is located under the plenum and intake manifold on top of the middle of the block.


Where is the knock sensor on a 1995 Toyota tercel?

It is located on the engine block on the opposite side of the exhaust manifold to the right of the starter unit.


Where is the knock sensor located on a 1995 Toyota 4runner?

its located under the head on the drivers side you can buy the wire separate 25 bucks the head has to be removed


How do you change knock sensor 1 circuit malfunction for 1995 chev sonoma?

The circuit 1 knock sensor would be located on the lower right side of the engine block (passenger side). You will need to drain the coolant from the radiator and be prepared for the passenger side of the block to drain coolant when the knock sensor is removed. After you disconnect the electrical connection to the knock sensor, the knock sensor simply unthreads from the block counterclockwise. Apply a thread sealant to the threads of the new sensor and install, no need to over tighten, this is a tapered pipe thread.


Where is the knock sensor located on a 1995 Dodge Intrepid 3.3 engine?

the library should have a shop manual for this vehicle, you can make copies of the right sections :)


Location of knock sensor on 4.0L 93' ford ranger?

It doesn't have a knock sensor on the 4.0 L OHV in a 1993 Ranger ( my 1995 Ford Explorer 4.0 L OHV engine doesn't have a knock sensor either )