If you are under the driver's side behind the wheel, it will be positioned on the left-hand side between the transmition housing and the engine block. It is a cylinder about 2 1/2 inches in diameter and about 6 inches long.
On your 1992 Ford Ranger , 4.0 liter : The starter should be on the drivers side of the engine , low down , where the transmission bolts to the rear of the engine
Your starter has gone bad and will need to be replaced unless you can take the starter to an automotive electrician and he may be able to fix it.
where is fuel filter located on a 1992 ford ranger
Where is the oil pressure sending unit on 1992 ford ranger
how to change a tie rod on a 1992 ford ranger xlt
What is a a/cl dv on a 1992 ford ranger xlt vacuum line
If the bolts have been removed and the wires disconnected, try tapping the starter with a wooden block to loosen it, Sometimes the starter will stick in place due to sludge and grime.
attached to your transmission
The 1992 Ford Ranger 4.0 liter had a 197 * Fahrenheit thermostat from the factory
A 1992 Ford Ranger is fuel injected so it would have an ELECTRIC fuel pump
The 1992 Ford Ranger ICM is located on the firewall in the engine compartment. The ICM will be on the drivers side of the firewall.
it is located on the side of the stater it will come when you remove the starter