diagram of starter in a 1993 ford probe
If the starter is spinning but not catching, the problem lies in the starter drive (also called bendix). You will either have to replace the starter or repair it by replacing the bendix.
a 99 ford probe doesnt exist
if the 94 probe is a GT, yes. the 2.0l alternators are different from the GT the autozone part numbers for the 94 2.0L Probe is 14449 and the part number for the 94 2.5L GT is 14450
r134a
Nope 98-94 is one model. 95 starts a new design.
inside the trans. not a job for amatuer
Yes,but the 93 and 94 enginges are obd1,while the 95-97 are obd2.
you have a magnetic starter on this vehicle, the starter is no good, you might try to hit it with a hammer to get it to start.
does anything need to be taken off to remove a started on 89 ford probe
Yes. body parts, interior parts and most motor componets are interchangeable. However, the 94 Probe is an OBD-I and the 97 Probe is an OBD-II so there are additional sensors on the 97 Probe to consider if swapping motors/wire harnesses, etc.
I Have 94 Probe 4 cylinder that squealed when I started it. the pully on the water pump was lose