TO THE BEST OF MY KNOWLEDGE THERE IS NO PLUG-IN FLASHER BASE FOR REPLACEMENT. IT IS IN THE ELECTRONICS MODULE LOCATED JUST TO THE LEFT OF THE ASH TRAY PULL OUT, DOWN TOWARDS THE BOTTOM OF THE DASH. THE "FIX" IS REMOVING THE TURN SIGNAL ARM/SWITCH AND REPLACING IT OR TAKING IT APART AND CLEANING THE SWITCH WHICH IS LOCATED IN THE STEERING COLUMN. TO THE BEST OF MY KNOWLEDGE THERE IS NO PLUG-IN FLASHER BASE FOR REPLACEMENT. IT IS IN THE ELECTRONICS MODULE LOCATED JUST TO THE LEFT OF THE ASH TRAY PULL OUT, DOWN TOWARDS THE BOTTOM OF THE DASH. THE "FIX" IS REMOVING THE TURN SIGNAL ARM/SWITCH AND REPLACING IT OR TAKING IT APART AND CLEANING THE SWITCH WHICH IS LOCATED IN THE STEERING COLUMN.....Addendum by Happy Gilmore: Yes the above is a good solution. I have a '98 Town Car and found that the turn signals and flashers had stopped working, but running lights were still good. I ruled-out the lighting control module, by having been told it was very reliable. The turn signal arm is fairly easy to remove. The steering column shroud (cover) is held together with Phillips screws underneath. But the steering tilt engagement arm will need to be unscrewed before the blinker arm can be pulled down and out. The tilt-arm is screwed in w/some wicked locktite. I had to use vice grips with a swatch of bike-tube rubber to keep from marring the metal. after that, the blinker arm can be removed with a 7mm socket, and the 2 wiring harnesses can be unplugged. After removing the arm, I cleaned the unit with a can of QD electro-contact cleaner (plastic safe) from the home center. I did this WITHOUT disassembling the actual blinker-arm unit. Instead I found numerous openings in the plasiic housing to inject the cleaner. After giving the unit a little time to dry, I plugged the 2 harnesses in back in, and everything worked like new.
The 1995 Chevrolet Corvette turn signal flasher unit is located behind the drivers side dashboard. The turn signal flasher unit will be above the brake pedal.
the flasher that causes the turn signals to flash But where is the flasher located on this car?
If I remember correctly, the flasher is built into the turn signal stalk and I think it's called the multi function switch. Good luck
The 1995 Chevy Camaro turn signal flasher relay switch can be found beneath the drivers side dashboard. The turn signal flasher relay switch will be between the gas pedal and the brake pedal.
The turn signal flasher on a 1995 Dodge Pickup is located on the driver's side under the dash. It is right next to the fuse box above the brake pedal.
The flasher for a 1986-1995 Taurus is located under the dash on the drivers side. It is at the fuse panel.
The turn signal flasher is located behind the fuse panel on the 1995 Olds Ciera. You will probably need to remove the glove box to gain access to it. fuse block under dash
The flasher is located under the dash on the drivers side above the brake pedal. It should say flasher relay on it
According to my Haynes repair manual, 1995 to 2001 models, the turn signal and four way flasher relays are located under the instrument panel to the right of the steering column.
Front seating area, driver side, under dash, mounted on passenger side of steering column.This is true and exact information but that is the location of the emergency flasherfor the hazards.Where is the TURN SIGNAL FLASHER located? where is tha turn signal flasher?
The turn signal flasher is located behind the ashtray. Remove the lower panel, where your ashtray is and it's right there.
The turn signal flasher on a 1995 Mustang is under the dash on the driver's side. Look for a square box that is plugged in using three prongs just above the brake pedal location.