Were what fitted............?
The threads of the screw as the threads are turned by the screwdriver .
the minor diameter should fall between 4.917mm - 5.153mm
Taps and dies are used to thread . A tap threads a hole and a die threads a rod.
the easiest way is to drill it out. drill a hole thru center of broken bolt, make sure it is smaller then the diameter of the bolt. after drilling use a easy out to remove the threads of the bolt. check that the threads in the head are ok! then put in new bolt.
M24 represents the outside diameter(O.D.) of the threads and the 2 represents the pitch of the threads(the distance between each thread).
Thread series cover designations of diameter/pitchcombinations that are measured by the number of threads per inch (TPI) applied to a single diameter
Pipe threads are stated in terms of so many threads per inch. For instance, a bolt designated as 1/4-20 is a 1/4 inch diameter bolt with 20 threads per inch. Divide one inch by 20 to find the pitch distance.
6.3
§ Screw threads have better compression strength than other threads. § Due to low thread angle there is no radial pressure on nut. § Due to smaller angle, the lead of screw is less.
§ Screw threads have better compression strength than other threads. § Due to low thread angle there is no radial pressure on nut. § Due to smaller angle, the lead of screw is less.
1 and 1/2 inches.Depending on the piping diameter one normally would figure for a 1/2" pipe 1/2 for threads
6 is the diameter of the shaft and 32 is the number of threads it has per inch.