Best area to search is ebay.
Forget about the Toyota; Buy American.
To replace a light bulb in the map light on a 1996 Toyota Camry, the lens for the light has to be removed. There are clips at two opposite ends that have to be nudged gently with a flat screwdriver to get the lens cover off.
Trying to replace the fog lamp lens on a toyota highlander 2005, Having trouble figuring out how to remove the defective ones.
go to the back of the lens and it should just twist out it shouldn't be too hard, then pull the light bulb out and it will say a number on it, or the whole socket comes out (Lightbulb included) and take that to the store and match it up.
If you are talking about the High Brake Light at the top of the tailgate; 1 Take out the two Phillips head screws in the lens. 2 Carefully pry the lens straight back . The gasket sticks to the paint. You may want to try a thin piece of plastic between the paint and the gasket. But be careful not to rip the foam gasket. 3 The bulb is a 921
The 2006 Jeep Liberty rear tail light lens does not come off. The tail light is seal. You can access the tail light lightbulb through the back of the tail light, in the cargo compartment.
Phillips screwdriver...two screws throught the lens. Remove the lens and extract the lamp. It pulls out.
To get the tail light out of the 1985 Toyota Cressida wagon, you will need to access the light from the inside of the trunk. Remove all trim from around the light and across the trunk latch. Then, remove the screws that hold the light and lens in place. You can then pull the light into the trunk.
Light goes in the lens, refraction occurs, and the light exits the lens.
The tail light is an assembly. The lens is not removable. To replace a bulb you remove the assembly by opening the liftgate, removing two fasteners, and pulling the light rearward.
Question isn't clear. Are you asking how do you replace the bulb -OR- how to remove the entire lens assembly?
Pry the lens off with a small flat screwdriver