Answer 1) At the Surface.
Answer 2) I disagree with the above answer. For practical purposes water is not compressible. Therefore the density is the same all over. The difference in density at the surface and at the bottom is so small that it is negligible.
However, fresh water is less dense than seawater, since the salts dissolved in the seawater makes it more dense. For that reason, if you consider seawater near the mouth of a river, that water will be less dense than the seawater in general.
Density is mass over volume, so divide 25 by 5(25 / 5) = 5 g/cm3 or g/cc
There is a wide variety of modelling clays: Mineral clays, are refined forms of the clay you may find in the ground, and are dense over two kg/lPolymer clays are much lighter, about 1 kg/land paper based clays can be very light, depending on their dryness.If you have an actual sample the best thing to do would be to measure it.
think of something ya self cheater
Circulatory as ventricles are parts of the heart.
You should frequently get it in the sectors on destiny islands for the lowest form of heartless if you want it quick use the stat cheat on the upper left of your grid
Look for the one with the lowest density.
Density = Mass/Volume
Grams is a measure of mass and milliliters is a measure of volume. The way they are related is through the equation: density= mass/ volume. Therefore you would need to find the density of the substance in order to convert the units. If you find the density then you would multiply the density and 47 grams to find the volume.
The density of strontium sulfide (SrS) is 3,7 g/cm3.
Divide the mass by the volume and you get density. the answer would be 8.98.
The formula for density is mass times volume. Therefore, density divided by volume would give you mass.
There are a couple that can help to find the best and lowest mortgage for your situation. One would be a Mortgage Broker. Another option would be a financial adviser at a bank.
The Min function gives you the lowest of a set of values in the values, cells or range you specify. The following function would display the lowest value entered in all of the cells between A1 and A12.=MIN(A1:A12)
Density can be used to determine buoyancy. To find out of something will float or sink, density is a good way to make a prediction.
You have to know two out of three ... mass, volume, density ... then you can find the missing one. If density is missing . . . Density = (mass)/(volume) If mass is missing . . . Mass = (density) x (volume) If volume is missing . . . Volume = (mass)/(density)
If an object was less denser than water it would float
You don't need density to find mass. In a lot of question you need to find density with the given mass and volume. But to find density you would use a triple beam balance. To find volume you would either measure the length, width and height or you could fill a beaker up with water lets say 50g and then put the object in the beaker and lets say it raised up to 80g all you have to do is subtract 80g-50g=30g. To find density with volume and mass you divide mass------volume and get density.