Ethernet
link-local address
To configure a GRE tunnel, create a tunnel interface by issuing the interface tunnel command from the global configuration mode. To configure the tunnel source and destination, issue the tunnel source {ip-address | interface-type} andtunnel destination {host-name | ip-address} commands under the interface configuration mode for the tunnel.
The exit interface configuration consumes less router processing time
The exit interface configuration consumes less router processing time.
All interfaces in the same classful network as the configured address will be included in the RIPv1 routing process.
the highest IP address of any logical interfacethe highest IP address of any physical interface
I'll go to hellis Cisco in a Cisco router. What would the prompt look like for global configuration
There are commands in command line interface for this . To know the ip address of host you can use Ipconfig command . Ipconfig command will also gives your other details as well.
mac-address
Anycast Address
The host portion specifies the particular network interface's address. The network portion specifies the network address.
It just means that you are not connected to wireless router. And in some cases it means that your wireless router requires configuration - type of security, password etc.