Home
 |
Which plug do you open to drain fluid from a 1991 Acura Transmission?In: Acura, Acura MDX
[Edit categories]
|
Answer
There is a bolt with a square cavity in it that faces towards the right side of the car on the drain pan for the transmission fluid.
I have been able to unscrew it with a ratchet wrench that does NOT have a bolt thingee (ie. 1/2" 3/4" etc) on it. I just use the square fitting of the ratchet wrench to fit in there.
Slowly loosen it (it will take a few turns to get it out) with a drain pan below and to the right side. When bolt is nearly all the way out, one can remove with fingers. Make sure not to drop the bolt in the pan, and be prepared for fluid to shoot out a few inches, especially when the transmission fluid dipstick is removed (helps fluid drain faster).
Wait 10-15 minutes for all fluid to drain out, and then replace with same amount of fluid that came out.
Draining should probably done with engine warm, but not too hot or the risk of burning oneself is greater.
After draining, finger tighten bolt, and use ratchet wrench's square fitting to tighten secure.
First answer by ID1082661859. Last edit by ID1082661859. Question popularity: 52 [recommend question]
- What kind of oil for a 2000 Acura Tl?
- Where are the water hoses for 1991 acura integra?
- What is the Thermostat on a 1991 acura integra looks like?
- If the automatic Acura CL 3.0 gearshift is stuck in Park because you can't push in the button but can release the gearshift using the shift-lock release what kind of problem is developing?
Answers.com > Wiki Answers > Categories > Cars and Vehicles > Asian Cars > Acura > Which plug do you open to drain fluid from a 1991 Acura Transmission?
Our contributors said this page should be displayed for the questions below. (Where do these come from ) |
| If any of these are not a genuine rephrasing of the question, please help out and edit these alternates. |
