2
June 29 2009
erwdsnbsm
I don't know, but i do know you need a massive @ss transformer!
Both are same. This is an instrument transformer used for metering & protections.
Center tap transformer is the such kind of transformer that is made to a point half way along a winding of a transformer.
how do you make a transformer on incredibots2
actualy it is, the japinese made a real transformer.
udhay
it is made out of metal It is made from 3 basic parts 1 a iron core 2 copper wire windings 3 a paper outer cover.
The transformer ducts are usually made up of strips of transformer board that is glued to the Diamond patter resin coated paper. It is widely used by transformers for manufacturing oil immersed distribution transformer windings.
Winding copper losses of a transformer can be measured in a short circuit test of a transformer. Impedance voltage is given to the primary and the secondary is often shortcircuited. (some times the reverse is done of this). Full load currents are made to flow in both primary and secondary circuits. This current flow heats up the 2 windings of the transformer. Power consumed at this time gives the transformer copper losses.
An ordinary transformer has two input/output terminals but a center tapped transformer has 2 input and 3 output terminals. One is taken from the center for a ground connection. This causes it to get 50% of the actual value. And ordinary transformer contains 2 windings. An autotransformer has one.
Devastator
2
2
Yes I think it is out in summer 2009