There is a clutch switch under the dash attached to the clutch pedal. This switch interrupts the start position of the ignition key, often this switch, or something in the circuit goes bad not allowing the starter to get the power it needs to start. Also check that you're starter solenoid is good.
K6
Mazdatruckin.com
.044
The 1992 Mazda b2600i holds 5.1 quarts of oil. When changing oil, add a little less than needed, then watch the dip stick until the engine is full.
The B2600i does not use a crank angle sensor, it uses a hall effect sensor located inside the distributor to time the engine based off of the camshaft. See the attached link for additional information. K6 Mazdatruckin.com
I have a 1992 B2600i 4x4. It's an automatic. I get about 17mpg on a good day.
B2600 has a carburetor system and B2600i has an injection system.
I Called the Mazda dealer today and talked with the Mazda Tech and asked him the location of the EGR valve on the 1992 Mazda b2600i. According to the tech only the California models have an EGR valve, I would think that any state with similar laws about vehicle emmisions would require the egr valve also. My truck is from Montana and it doesn't have an egr valve which explaines why I havent been able to find it.
121 hp
Under the drivers seat
You can try your local auto parts recyclers (junk yards) or you can go to an auto glass retailer.
Firing order is usually 1-3-4-2. So start from the front of the pickup, going clockwise. (mine is a 1991 Mazda b2600i).
on the firewall passenger side
yes you can pretty much turbocharge anything.