0
Why do you press harder on the remote control when you know the battery is dead?
Wiki User
∙ 15y ago
Answer
Lack of self control might be your answer. maybe you're hoping that there's little remaining energy left and by pressing harding you'll gonna catch 'em People can get frustrated easily and keep trying to make something work even when they know it won't work. It could be lack of focus.
== == == == == ==
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Why do you press harder on the remote control when you know the batteries are running out?
coz the battery is low
Why do you press harder on a remote control when you know the batteries are getting weak?
Because you are a neanderthal.
Why do you press harder on a remote control when you know the batteries are flat?
so it could work
How do you activate the 2nd wii remote in smackdown vs raw?
open the front panel on the wii, press the red button then press the red button on the remote closes to the battery open the front panel on the wii, press the red button then press the red button on the remote closes to the battery
How do you use PIP on a Charter remote control?
To use PIP on a Charter remote control a person will need to press the PIP button on the remote. Then enter the channel number of the station they wish view in the PIP window and press the select button.
Replaced battery in remote now red light comes on remote and car central locking and alarm goes on is it remote or fault in remote?
I had a problem too when I removed the battery from my Mentor's remote . Do the following ,sit inside the car , remove the remote battery , wait for 1 minute , replace the remote battery when doing so you will see that the remote light is on ! If the light is not on try again ! Now press and hold the lock button on the remote until you hesar the doors lock . Your remote is now programed .
What buttons on dish remote control DVD?
Once the DISH remote is programmed to your DVD player, it can be operated in AUX mode. To get to that mode, press the AUX button on the upper right corner of the remote control.
What would cause your automatic doors on my 2005 Freestar to stop responding to the keyless remote and overhead console?
If you have a loss of power (blown fuse, replace battery, etc.) you have to reprogram the remote controls and overhead console. Turn ignition off to run 8 times then press button on remote control.
How do you connect a remote to the wii?
you open the thingy on the Wii system (a red button) and press that, then you open the thing on the Wii remote (where the batteries go in),which is a red button,and press them both at the same time. if you are talking about a normal remote,then that will not work on the Wii. you should ask an adult or if you are one,then you should know how to do it, but use your brain,not smart dumbo!
My Wii remote cursor won't show up on my screen how can i fix it?
Synchronizing Wii Remote: Press the power button to turn on your Wii console. Remove the battery cover on the back of the remote . Change the two AA batteries. Open the door on the front of the Wii console and press the RED (SYNC) button at the same time push the RED (SYNC) button in the battery area of the remote. That's all now have fun.
How do you reset parental control on rca DVD?
Press the Stop button on the remote control and at the same time press the Stop button on the DVD player itself for 10 seconds.
Lost remote usage after replacing battery 1999 Dodge Durango?
press on your remote the lock button 5 times at 2 sec intervals in order to synchronize your transmitter.
