answersLogoWhite

0


Best Answer

I have a 1992 Chevy berretta 3.1 V6 and when it is in park and reverse and neutral it sounds like there is a grinding noise right below the shifter I know that the linkage needs adjusting any ideas

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does my car makes a grinding sound when in park or neutral?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Makes grinding noise if it is in park?

It is a 2002 Honda civic


What would cause grinding from moving car gears to park?

OK. If you are sitting on a hill more than 15 degrees, if you do it will make that grinding sound. in most car booklets say on a Hill 15 degrees or more put it in neutral than apply the emergency break. and you do not need to be at any speed when putting it into park.


1990 Honda Accord makes a grinding sound when in park or neutral but not so much when in gear don't believe the CVs are broke any ideas?

for starters it wopuldnt be the CV axles because they will only make a noise when driving. sounds like it is going to internal inside the transmition, like the gears not lining up right


Why would the transmission make a grinding sound when putting it into park from drive but not the other way around?

you have got to make sure your not rolling


When was Indian Grinding Rock State Historic Park created?

Indian Grinding Rock State Historic Park was created in 1968.


Why does your 99stratus 2 4L makes a grinding sound when you start it and when you shift to neutral and park?

The noise you are probably hearing(if it happens everytime you change from Park to Reverse and to Drive is most likely just the selenoid on the trans. Chrysler managed to make that thing one of the noisiest on the road today. If it seems excessive I suggest having it checked, but "normal" is a 1/2 - 1 second "whaaaa" sound. Hope this helps! : i also have a dodge stratus 2000 that had grinding nioses when i wnet forward or reverse or just parked, if your break line is cut your motor mounts could be out, the grinding would be cause of the engine rocking back and forth i had to get new mounts and its costs me about 200 through the dealer and 500 for the breakline, but check all your motor mounts , all is good after!


Park Ave grinding sound in front pass drive axel?

Inspect the Cv boots on the axles for tears. If no tears are found then replace the wheel bearing.


What is a park neutral switch?

It is a switch that only allows the starter to work when the transmission is in neutral or park.


Why does my 1995 Firebird make a grinding sound when you put it in park and turn off the ignition What could this be?

sounds transmission related or possable flywheel related That would be the power headlight motor!!


Why can I start my 97 ranger in neutral but not in park?

neutral safety switch


What is the difference between neutral and park?

In park the park pin is engaged to prevent the vehicle from rolling away. In neutral there is nothing to prevent the vehicle from rolling away


Why does starter keep engaging in 'park' in my 1999 F350 Diesel 7.3L even after the engine starts?

sound like to me the starter solenoid is stuck the reason it does it in park is the neutral safety switch replace it and it should be fine