answersLogoWhite

0


Best Answer

Two thoughts: you may have put the battery in wrong (if it's not all the way in, they chirp) or you may have put in a dead battery.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does the smoke alarm keep chirping after installing a new battery?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why is smoke alarm clicking?

new battery


Location of backup battery for smoke alarm?

In the alarm panel box or an auxiliary box nearby.


Is there an online resource that shows how to install a wireless smoke alarm?

There is a alarm forums that mention several ways of installing various alarm systems including wireless from professionals and amaturs.


Why does your smoke alarm start beeping when you use your treadmill?

The most likely reason your smoke alarm starts beeping when you are on the treadmill is it needs a new battery. It is a coincidence that you are on the treadmill when it is alerting you.


How often of a smoke alarm battery?

You should replace your batteries every 6 months. Smoke detectors save lives!


Why does Nighthawk Smoke and Carbon Monoxide Alarm keep Chirping about every 30seconds even with new batteries?

because after 7 years it needs replacing. It's in the manual.JB


How can you keep the smoke detector from beeping temporarily?

Push the button, or take the battery's out (not recommended) In many modern smoke alarms it is impossible to remove the battery, but there may be an on/off switch that can be actuated with a tool. If the alarm is beeping because the battery is dead, replace the battery or the entire alarm unit, which should be done every ten years anyway. Removing a battery in any smoke detector could be criminal "tampering", if anyone gets hurt because of it.


How do you change the battery in a smoke detector?

Smoke alarm batteries are easy to replace, once you find where they go. The design varies from brand to brand. Usually, the battery is located on the side of the alarm, either in a "drawer" or a swinging compartment. There may be a small plastic latch holding it closed. Occasionally, it is necessary to remove the alarm from the wall or ceiling to find the battery compartment. This can be done by rotating the entire alarm counter-clockwise until it releases. The battery compartment is designed not to close if the battery is inserted incorrectly. Many smoke alarms have an option to permanently screw the battery compartment closed. This is typically done in rental units to prevent tenants from removing the battery during a false alarm. In this case, the landlord is required by law to change the battery. If you are the landlord, consult the alarm documentation (which can be found online) for instructions on how to remove the locking screw.


How do you get a smoke detector to stop chirping?

For a battery-operated smoke detector, you simply remove the battery. For a mains-powered smoke detector, the only way to disable it is to disable the mains power running to it.However, both of these methods are not recommended, as people tend to forget to turn them back on. Instead, open a window and run a fan to evacuate the smoke.


Why does your smoke alarm upstairs makes a sound every 10 minutes?

The main cause of this is a low battery. Most smoke detectors are designed to send out a low beeping sound (sometimes followed by a flash of the red light in some but not all designs) when the battery is low, to make the home owner aware they need a new battery.If your smoke detector is wired up to the mains of the house (as the new UK laws state they should be in new homes), then the beeping/chirping will still occur if the backup battery needs replacing.Once you have changed the battery, you may need to hold the test button down for around 30 seconds, depending on the make and model of the alarm (refer to the manual).If changing the battery does not resolve the issue, then there is likely dust or dead insects interfering with the alarm. You should clean the alarm with compressed air.If the alarm is sticky from nicotine, you will most likely have to purchase a new one. Nicotine contains hydrocarbons - and so does fire and carbon monoxide. But nicotine is sticky and therefore almost impossible to clean out of the alarm filters. You should always avoid smoking in the same room as a smoke detector (or even better, don't smoke indoors at all).Failing that, the alarm might be faulty. If it is a battery operated one, purchase a new one. Or contact your local fire station on the non-emergency number. In the UK, some people such as pensioners are eligible for free smoke detector replacements from the local fire service.If it is an electrical one, contact the manufacturer or the local fire station on the non-emergency number.


How do you shut off a smoke alarm that doesn't have a battery but runs on electric?

Hit it with a hammer...or disconnect the wires and reconnect them


Where would you not install a smoke alarm?

I would not install a smoke alarm, in the kitchen.